Search results

Dont worry, safety is paramount. I did mean buy official part. I just didnt know if this would work. When you say 3.2mm, I assume that means 1 x 3, 2 x 0.1mm? I did lower speed yes, have only tried one test pass, however without switch (not arrived yet) its to dangerous. Shimmed? Im having...

this is the cutter, as its adjustable I dont know if i can place a washer in middle to upsize it. Max for cutter says 18mm. Stock is 21. Also was planning on oak veneered ply 9mm for Panel. Dont think i can get 6mm. But if poss can i rabbit the back of panel to fit? I will look for new...

I wish I had of done that, good plan. It was from 1/2' Trend cutter set from SF. 6.3mm, it did sound strange, I have heard you can learn from that! All good practice, I think I pushed to hard tbh. I did rip oak board after to make my door sample leaving about 2mm, then tried bottom guided...

No, I was planning on using stock they have as I hoped the size would be fine, and in 5m lengths the most economical. They come in 94mm, 21mm, 5m. So I wanted to use chop saw to cut to length, and tounge n groove on router table. hoping it would be efficient as lots of work with little time.

I am not sure if this is the quickest or easiest way to cut wheels but I wanted to try it anyway as my router table is heavy and needs to be more portable. I cut in 3 passes as 11mm ply, but managed to snap my first bit 😕. I think it might have been too thin a bit or I went too fast. All...

No, I have limited tools and lots of cupboards to cut. Is there a standard for thickness I wonder. I have a plank of 5x1 oak which I have cut into what i think are correct lengths to test but cant until I resolve this problem. The other issue I have is inserting centre board, which are 9mm...

I have started practice runs for making shaker doors for my kitchen makeover, using a similar cutter this this fromTrend. New to routers and this is first time I have used table I have made. My first school boy error was to not read box correctly for cutter. I was planning on using oak 4x1 for...

yea, this one from trend. I get ya, if i measure it right it may help stop stock rising, or should i give a little clearence. Actually it will snag the cutter if that low i guess. And safety first, I hear that. Thats a great app you use fordrawing, or program on pc? Have been on...