Search results

Here it goes LIGHT BLUE TOUCH PAPER AND STAND WELL BACK

Tell me is it a combi !!! Mine does it every time on start up/burns bangs boils prv open discharge fill it up cause it`s empty then it`s grand

Jet blue Good gear

Ha ha ha ...... He will or the gas guy will, I gave it a coat of looking at but thats as far as i go

Cheers Mike, He checked trip and says it`s ok, the darn thing was running when we were there finishing our job could it just stop like that. Gas valve eh

Hi folks, A customer of mine`s combi went out and wont start up again He says the pilot light wont establish , hes changed the thermocouple but no sucess cant keep it lit Any ideas

Aghhh Mary Surveyer Plumbing Required Hours to suit Pay neg Van supplied My Guy`s are ****e

As step 1 if it works As step2 Re the picture On the left is a brass hex nut, underneath it is the supply pipe, you can just make it out,the bleed nut is the one behind it. Open it up one turn first with a tub underneath it to catch any oil,stinks for ever, Turn boiler on, this...

Aghh the old defiy ing gravity trick Oil will move up hill to a certain extent "as long as the pump is on, as in level with the burner or just above The connection you need to bleed is as the picture posted for refference underneath it is the supply pipe,the silver braided hose, behind...

Flush or drain the rads would be a good start!! The bathroom rad is on the coil circuit and possibly on gravity which is why top and bottom entry If you fit a trv to the heat dump rad and it closes down be prepared for the DUMP :oops:

After you have bled the pump try it,if no joy,step 2 Step2 Crack it open just a turn or two,turn the boiler on"but be ready to shut it when oil dribbles" Let the pump itself bleed it :idea:

Bang :shock:

The trap has many many adjustments, if you move it around in place you could just about eliminate the 90 bends and acheive a good fall.You may have to buy a soket and some pipe. But looks like the guy left some under there

Seco services Spot on right on the money. 8)

In`t there a required fall for drainage 1:40 or 1:80

Where`s the overflow connect in!!!!!!! Darn it not quick enough

Is it the valve tail into the rad :!:

Think this is how it happens (and some other members may have a take on it) Do you remember this toy The small steel frame with four steel balls suspened side by side, pull the first let it go and it pushes the forth one out from the pack and the whole cycle starts again. This is what happens...

You sure it`s not water hammer from the ballcock washer and seat in the cistern