Search results

Good Point!

Thanks seco, are they readily available?

Sorry seco for being a bit slow here, can't see it bringing it down enough?

??? Sorry did not understand your answer!

Hi, In regard to the above could anyone state if it is nessessary to fit a metal plate for rigidity between the mains supply and the 50 gallon plastic storage tank in loft. Seen it a couple of times before and wondered if they are generally fitted! Many thanks!

Reliance recommend using in-line filters before PEV Are these normally bothered with may I ask Just trying to get an opinion as to whether I should fit them or not......the valve itself would be assessable for maintainance! Many thanks

You're all stars! Thanks everyone!

Thanks for that, any idea of price?

Hi, where are they available from, and would that be suitable for my purposes! Thanks

I thought that was what they were designed for, I know they tend to be 3 bar max! Thanks

Hi, I have unbalanced feeds to my future shower, cold on main and pumped hot. My question is, rather than using a purpose built pressure equalizing valve before the shower, do some showers/mixers have them built into them! Many thanks

Thanks for your advise, as the hot water cylinder sits 14" or so from the floor on a frame, and is a 28mm feed from the cold water storage tank, I will use a 28mm x 28mm x 15mm tee on entry to the cylinder (not allot of room between entry to the cylinder and wall), run a short 6" or so length of...

Any recommendations?

Does that mean that pre-sodered fittings come in lead and lead free solder?

Not lead free?

Hi, Do current yorkshire fittings contain solder that is lead free, if so, does that mean that you would have to use the newer type flux (for lead free solder) or is the old type still ok to use? Thanks!

Thanks for that

Hi, Would it be normal or standard or indeed nessesary to fit a drain valve at the lower end of the feed to a direct vented hot water cylinder. Many thanks!

Hi, thanks for that, I was not sure that if it were not run vertical within reason, it may aid sucking in air at the pump. In the loft I will try and use a 45 degree angle as much as possible rather than 90 degree horizontal. Many thanks

Hi, Could anyone tel me how important the run of the 22mm vented pipe up to the cold water storage tank in the loft is, the vent would be running from the top of a Surrey Flange as the hot is pump fed. What I really needed to know was, is it important for the 22mm vent pipe to be run as...