Search results

I'm looking at going out on my own so just getting a few quotes together for public liability insurance and indemnity insurance. Can anyone recommend any particular companies? Thanks

Hi, I fitted led stair lights in my house a couple of years ago and also in a restaurant about 3 years ago. All still going very well and looks the dogs.. I used collingwood lyte type fittings, pricey but they are nice and good quality. Check them out...

Hi, I'm installing some led strip/tape about 14 meters.. This needs to be dimmable but the switch line upto the dc driver is 230v as it would be as a normal switch line. The problem I have is that it appears that the LEDs which are 12v can only be dimmed on the load (12volt) side of the driver...

What do you think about these www.cctvdirect.co.uk/categories/CCTV-Kits I was planning on mounting the cameras on the soffits, its a normal height house.. Does this seem like a reasonable idea. This way I will avoid running cables down external walls and pulling up floor boards..

Hmmm no. I'm 29, much to old to dig..,

Yes that's an idea, just going to look pretty pants, but it is an option...

Where's the best place on the net to get a kit?

It's getting the cable between the house and the garage being the problem...

I was thinking wireless only as the garage where I wanted to mount a camera is some distance from the house. Running cables to it could be tricky...

Hi I'm looking at installing a CCTV system for my parents place and I'm unsure which system to go for. I'm a spark but CCTV isn't something I normally do. They are after 2 to 4 cameras, one being mounted on their garage so wireless would be preferable (obviously I know power will still be...

Is that easy to access and unblock? I'm a sparkle so pretty capable but need pointing in the right direction. Thanks

I have an indesit dishwasher not working propery. To start the diry water hasn't drained out of it and then when you put it on to run it again it sounds like it tries to drain and then carries on cycle, it doesn't fill with water but the elements heat up and just hums a bit. Any ideas? Thanks

Hello Quick question on building my new front wall. (not me personally) I'm thinking of having a new front garden wall built. I want it to be a block work wall about a meter high and for it to be rendered smooth including the top of it. In the middle of it on the cavity I wanted to fill...

Thanks RF What about the fact the steel conduit that they supply the VIR to the head is not earthed. Could this be good reasons for them to change it?

Hi guys, I'm doing a job at the moment where the incoming supply is VIR. It's a terrace house and the supply if fed from next door where I presume the incoming cable is. There is a cut out and meter in the house I'm working in only the cables feeding cutout are VIR and there is no Earth. Also...

I dont have anyway around the joint being under the floor boards. Any other suggestions? The 22mm pipe runs litratly about 2 meters straight.... I can't see any befit from that? Can there?

Hi all, I have extended my kitchen and now need to move my water main as it comes up in the middle of my kitchen now. The pipe is lead and joins to 15mm copper to main stop tap. I need to remove the small amount of copper before the stop tap to enable me to lower the pipe to extend it under...

Hi, I've had a small extension build on side of my kitchen and just had a question about the depth and possible membrane of screed. I'm going to have a timber floor and below that my building inspector has asked for a screed 6inches below bottom of floor joists. I'm not able to contact my...

It's done just over 100,000 miles so yes it's high. Im planning on selling it ASAP so didn't want the expense of a new rad. I will try the flushing 1st and go from there. I presume the rad should be relatively cold when upto temperature?

Thank guys, How can I go about fixing it. Should I try flushing the rad? I take it that having no coolent in system and only water should still be ok then?