Search results

20mm drill hole for cable entry from soffit and use screws provided with camera to install

The orisec bell range has bright LED’s that can be seen clearly during the day.

Long time since I’ve had to look an accent a bit from memories... connect keypad back up....open up main panel... enter code to silence. There should be a volume pot on the main PCB that you can adjust? Once done close main panel lid then press reset on the keypad. Hope this helps.... check...

Looks like you have a problem with zone 5?

You can adjust the volume on the main panel board.

Plus there should be a 3amp in switched fused spur installed so you can turn the supply off to the alarm panel safely. I have never wired of a light supply.

So when you switch the light on the power to the alarm panel goes off? Power for the panel has been taken of the switch and wired wrong. I would suggest you need an engineer/sparky to have a look at this. I don’t like the sound of something electrical buzzing

Hi, Before I paint the kitchen I have 2 problems with the ceiling and wall. The shower upstairs leaked through and the wee side bit of plastered wall has come away. Is there anything I can do to repair this? thanks.

Night setting would be a part set so the upstairs landing PIR would be off. When you come downstairs the Hall PIR will be on entry exit and give you time to switch off. Another option would be a wireless fob that you keep upstairs to part set at night. This would save you from having to use the...

Has anything changed on the port forwarding of your router?

Sensor probably needs a new battery. I would advise changing all the batteries in the sensors at the same time.

You will have no problems installing the alarm panel in your garage. I have fitted loads in garages and never had any problems at all.

Have a look at Orisec equipment. I have been installing this for 2 years now and find it excellent. Used to install Risco for 16 years before that so it was like a breath of fresh air!! Pyronix are also decent but cannot comment on Texecom as iv never used them but their kit looks good and I do...

It will normally be a loose/faulty transformer.

Another way to do it so the cameras are lower is to run the cable behind the drainage down pipes to your preferred level. The cable still has to be protected so usually 16mm oval trunking then fix drainage back up covering the trunking.

You will definitely need the eng code if the panel is locked. You will need to default the codes(if the panel is not locked).

Yes as above always use quality copper cable.

What type of router do you have?

Have you tried www.aliendvr.com for help as theres loads of info on there. Click on the British flag on the homepage and this will take you to a page to test your port forwarding. With some of the alien dvr's it will not open up the ports automatically on some routers. What router do you have...

I really like the Orisec equipment as it’s good to install and easy to use for the customer. App is really good. Had a faulty panel(touchscreen) and had to replace but their tech service was great. Their micro door contacts and shocks are way above the Risco and Pyronix equivalents. Anyone had...