Search results

Thank I have to swap one on a basin. So I will likely need to swap the waste as this is pop up. To swap it it would be easier to remove the basin and pedistal?

Do they do them with a clicker waste instead of push up via the bar

Thanks do you have to set the height of the tap body though the basin to accept the shroud?

Are 3 hole basin tap/ mixers easy to fit? Have not do one before.

Do you mean change the full valve? I was hoping to split the valve and change the body.

It says en1213 on the valve that's in

Thanks it looks like someone has had the body out before with the PTFE around it.

It's 25mm to 15mm I am hoping to just change the valve head not the whole body. Is this usually doable?

This stop tap looks like it has had a poor repair in it in the past. Could I change just the head of this stop tap? If swap the full valve the distance the olives on the pipe maybe different.

That's the one I changed.

Is it ok to change the body of a drain off. Unscrewing the insert and screwing another in?

Thanks, on say a new build how wide would they make an opening originally for a 900mm shower tray. Fit in like a u-shaped opening? Is the tray always better sunk in to the plasterboard?

There's the skimmed plaster board either side at around 15mm a side. After the 875 opening. I may be able to get away with just cutting this out? Guessing one side I would have to cut quiet high to lower down at an angle?

I am thinking of swapping a broken shower pod. For a stone resin shower tray and shower panelling the opening finish plaster to finish plaster (stud walls) is 875mm would a 900mm tray fit if I cut away the plaster board at the base? Also would the shower door fit as the encloser would be smaller...

Maybe just drop abit of pressure out of the loop then first? With regards to draining after flushed do I need to fill and drain a few times to get it all out? Or is one drain of the system after treatment ok.

Can this be added to the system via the filling loop without draining? Not use these rapid dose cans before.Thanks.

What would the current scrap value of a stainless steel kitchen sink be?

Thanks I went to a job were someone has put the washing machine waste in to the pipe run with just a tee and an appliance connector. No trap. However no noticeable smells. Can washing machines have non return valves on the machine to stop this?

Thanks so the possibility of the washing machine waste hose end being submerged in the trap is not a problem?

When putting the waste from a washing machine in to a standpipe what is the best way of clipping it so it doesn't come out and also so it doesn't go too far in and sit in the water of the trap. As this can lead to it back syphoning of the trap?