Are 3 hole basin tap/ mixers easy to fit? Have not do one before.
3 hole basin mixer tap
- Thread starter XanderHarris
- Start date
Sponsored Links
Easy enough I always put waste in first assemble other parts loose make sure tap shrouds fit where they should tighten up simple!
Thanks do you have to set the height of the tap body though the basin to accept the shroud?
Do they do them with a clicker waste instead of push up via the bar
Sponsored Links
All I've done have been rod type pop up
Thank I have to swap one on a basin. So I will likely need to swap the waste as this is pop up. To swap it it would be easier to remove the basin and pedistal?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
