Search results

Ok so the boiler now works, has a fan fitted by a skilled guy, and because you feel the bill was steep he should of checked it better? You don't know a thing about gas boilers but the rgi did, but because you stood and watched like a hawk and think hey that was quick and looked easy how come the...

Easy boiler to work on but the fault sounds like it is a part that a rgi needs to do so get someone in.

To add the newer magnaclean does have a collector for debris now at the base. But still a vote for the tf1 more addaptable to fit too

Tf1 gets my vote, but magnaclean twin tech does intrest me more over the standard magnaclean.

Learn how to shut water off, is a first then get a pipe cutter and a plastic cutter, buy a shed load of plastic and push fit fitting push them all together. Turn on water quick test don't give a dam about water regs or sod all else box in pipe work make sure no clips are used. Come on here a lot...

Did you have the system installed or was it fitted when you moved in?? It may of had a non return fitted to the flow by a third party if it was causing crossing over when just the hot was on, so when plumbing the new unit in the installer may of had a the fault you described but instead of...

Running cost won't be a massive change, a clean and set up sytem would be better money spent. I wouldn't change it the savings you get will pay for parts on the new unit. Potterton suprimas are a Rick hard boiler pcbs a common but that's a small cost over some problems you get with steamers just...

Gunna get moaned at but call vaillent for a one off repair cost, the boards are dear so you connect it wrong it will be bad times.

Runs into overflow bottom left corner. Tell ya what house wife go look outside, if the pipe looks in line may only be a case of getting the pipe pushed into the over flow, then connected to the copper so the overflow is a sleve most over flows behind baths ate straight.

You can run a tprv into plastic if done correctly if you have the correct quals you will know this still isn't a reason to not issue a ticket and correct its ncs.

It isn't a safty issue though, on cp12s (landlord inspections) it isn't covered you can note as advice but that's it! If the boiler had been shut off you can legally sue the company. It is not gas related so no sticker should be attached end of! Yes its rough but that's it, is it dangerous? Well...

When it was serviced did they do a smoke test? Had this after some rgi used a cheapo pellet.

They start nice then start going black unless you buy a very good fire paragon seem nice and work well. Focal point are cheap junk imo

Sod it do like the rest and just go it alone got blokes that get work off me by under cutting me after doing a 6 week coarse. Everyone I meet is a plumber these days. Good luck.

If you fit the most expensive and best coals this will happen, they are only fake coal and do take a beating. Make sure they are set up correctly as this will aid the colour change

It's the flux capacitor

Only improvement for ferolli is not fitting them the mondena was a good unit imo, now they are just a PITA

Apologies but that's what I was getting at.

In a word no, it wouldn't conduct the heat in the water quick enough to transfer throughout the rad pipework and rads to heat the rooms mainly to do with heat loss and if you could the solar panels would have to be huge, hence ground source and air to heat.

Daam gotta be quick on this site