Search results

  1. T

    Sleeving a pipe

    Is there anyway if sleeving a cold water pipe that is already in place through an air brick. Without cutting the pipe. Thanks
  2. T

    Flat washer or concaved?

    That's flat so would be flat washer?
  3. T

    Bath waste rubber

    Maybe just a bead of silicone here then?
  4. T

    Flat washer or concaved?

    Thanks yes alot of taps now have a fluted end so you could connect on with a nut and olive? Though be hard to get enough force to tighten with a tap spanner
  5. T

    Bath waste rubber

    Usually throw top washer and use silicone. Not used one of these one piece washers before
  6. T

    Bath waste rubber

    So maybe just silicone on the bottom bit were it meets the bottom of the bath?
  7. T

    Flat washer or concaved?

    Guess it depends if the tap face is flat, then id if the flat washer. If it tapered, alot of taps seem to be now. Id fit the concaved washer?
  8. T

    Flat washer or concaved?

    This type
  9. T

    Flat washer or concaved?

    If using Hep2o plastic tap connectors, do you use the flat washer or concaved one that comes with it.
  10. T

    Patching render

    Thanks to me it sorted if looks like it's been gone over with a brush. SBR bond the surface before apply the mortar to match the render?
  11. T

    Patching render

    Thanks how would you roughen it up to get a similar effect to what's in?
  12. T

    Hire core drill bit

    Can you hire just the a core drill bit?
  13. T

    Patching render

    The new hole wants to go something like this. I do have a core drill and diamond core but it's only 110mm wide.
  14. T

    Patching render

    Thank you.
  15. T

    Patching render

    Can you Stitch drill a hole through render or will most of the render fall off around it?
  16. T

    Patching render

    Ok thanks. So if I cement a cut to shape breeze block in and leave 25mm back. Someone will be able to patch?
  17. T

    Patching render

    So if I patch with a breeze block set 25mm back from the face of the render. It should be patchable, to match? I'll probably get someone in to do it. Thanks
  18. T

    Swapping bath tap connections

    Haha no but I would be
  19. T

    Patching render

    This is the finish
  20. T

    Patching render

    Not sure how to get the Finnish on the renders it's not a smooth finish
Back
Top