Search results

Thanks they are trvs

Yes I can repipe the rad Just wondered if it's usually ok to reuse the valves?

Thanks I would be taking the radiator tails out of the old radiator putting in the new. And repiping the radiator. I need.to drain down to alter pipework slightly.

If swapping a couple of.radiators for slightly different sizes so draining down. Would it be possible to use to old rad valves take the tails off put in the new rad. Etc? Or unadvisable? I think I'd just need some new 15mm olives for the copper pipe size. If I do. Thanks

There is no gas would need to be stored hot water.

It's not a home, it's a commercial unit. With 2 basins and 2 kitchen sinks needing hot water.

How much stored hot water would be needed to feed two kitchen sinks and two wash hand basins?

Thanks there is no appliances on the run.

I usually try and run the waste under the plyth. If this isn't possible is it ok to run higher up behind the unit. I think there is usually a 75mm void? Would then require the joiner to knotch the back of the units.

Have seen before look abit odd

What is the unit called that the ground source heating pipes go to to transfer the heat from the refrigerant to the heating pipes to go around the system? Thanks

Any tips if they do resist abit?

Thanks the chrome tap heads should pull off easy enough?

Thanks the heads usually remove ok after removing the grub screw at the back of the tap?

Thanks I have the spare ones.

No as in you swap as only dealing with the top of the tap?

They are dripping so guessing ceramic discs cartridges worn?

This is the tap

No access panel just fully tiled

Would you swap bath tap cartridges on a bath tap were the bath panel is all tiled in? I'm just thinking of something went wrong can't get to them.