Search results

If I turn the dusk/dawn anticlockwise the light stays on but need to switch it on/off/on for this to happen. otherwise if I just turn it on once, only the pie function works

Switching it on once activates pir. Switching it on/off/on activates dusk till dawn. Think it’s 2 new lights with no pir or photocell

Just tried that. I turn it on once and stays on for about 7 seconds, then goes off. I then wave my hand in front and it comes on for another 7 seconds and goes off

Just tried that. I turn it on once and stays on for about 7 seconds, then goes off. I then wave my hand in front and it comes on for another 7 seconds and goes off

The instructions are below. But don’t think they can be overused: https://www.universal-lighting.co.uk/assets/el-40062-40063-instructions.pdf

Hi again all. After successfully installing some soffit lights, which work amazing with the Quinetic WiFi receiver, I’m wondering if a can buy another to control my outside up and down lights. The only problem is the dusk till dawn lights I have at the moment require you switching them on and...

Just took the fan isolator plate off. Is it just a case of running a twin and earth 1.5mm wire from L1 and neutral, then dressing the earth cable into the existing block then run it into the loft and then into my quinetic receiver?

Yea RandomGrinch is exactly correct. Not 2 wireless switches in series.

If I break into a cable in the loft it would be a switched live and would only work with bedroom light on. I need a permanent live which will only be present at the switch.

I am taking the feed to a Quinetic WiFi box that I will screw to a truss in the loft, controlled all from the quinetic app then and a wireless switch by front door just incase app fails to work

Hi guys, I hope somebody could help. I’m going to be installing 3 soffit lights in the next few days. I’m wanting to get a feed from existing lighting circuit, but all my lights are actually looped at the switch rather than ceiling rose. Rather than fish to a switch in the bedroom, could I...

I’m going to install a Quinetic that you can control with phone, switch or schedule to come and go off at certain times

Just they live in a street with no lights so it’s just to light the house a little really

Hi guys, wonder if someone could help. I’m planning to install some soffit down lights for a friend. Could any of you guys advise where I should place them. Obviously can only place them on the right side of the house where the soffits are.

Building regs will need to be involved yes but your builder sorts this out

Yea the block work is there to build off already. I’m not sure about the insulation in the floor though.

Hi there. Have you got a haddenham house type? We just used the existing floor as there was a dpm under the screed. Not to sure if it was insulated though. These new houses are built on block and beam so not in direct contact with the ground. We are having laminate put in the conversion so an...

I’ve had the same with my outdoor porcelain slabs. Manhattan grey I used. I followed instructions exactly. Had a technical person come out and then analysed it to no explanation. Basically I have come to the resolution Mapei is crap in lighter colours. Basically had to grind it all out and use...

Has anyone got any advice on this at all?

It’s 12mm laminate with a 5mm underlay. I’m sitting hear searching the internet. The only 35mm bar I can see is laminate to carpet. Do you think I could use one of these thresholds and knock the spikes flat that are supposed to go into carpet?