Search results

are there any good guides?

Hi I have a 3*4 m patio that over the years has sunk in a one area about 1 inch across 2 stones. Is this easy to remedy? luckily the are on the edge. what are my options and costs etc. Thanks

cheers - recovering from an operation at present so will have a look in a week or so - cheers

so turn it on its back? or do you mean inside by the dome? I cleaned another little tube by there too?

anyone?

Spoke too soon - the same happened. I need to find the float with / water metering system

took out all the normal filters and this leaves a little dome with a screw on it (inside the wash area on the right hand side) Removed the screw on the top and lifted off the dome. Inside are 3 little tubes ( 2 the size of a pen and the other a little smaller ) Took a picture of these so I...

Hi Dishwasher hasn't been moved or anything altered to it. Noticed a week or so ago that glasses didn't appear rinsed well, but had washed. Changed tablets - still the same. Watched a cycle - drained, filled, but looked like not enough water. Looked like it then went through without rinsing...

Thanks The setting I was looking at was whereby it will kick back in after a 1 degree fall - this can be changed to 2 degrees etc. I think I read somewhere about the number of times it can come on in an hour too - will have a look

Not sure whats what there

Hi On the above programmer / stat I fitted, you can set the accuracy of when it turns on and off to maintain a constant temperature. Can anyone tell me what this should be set at - e.g. 1 degree or 2 degrees etc. Thanks Nick

Bought one - 2 wires - job done. Programmed and working superbly!!! Thanks to everyone. Cheers

Ha Ha It won't blow anything then - ok mate - so ok to go ahead then - cheers

Hi and Thanks I haven't purchased one yet, can leave the timer on permanent too. Just measured across the 2 wires and there is 240vac. How do I check a switched live to control my heating?

Replacing a honywell? 4200 3879-001 room stat someone suggested the above programmable stat. can someone tell me where the 2 wires from the existing stat go on the new one. Thanks

Anyone?

The existing stat says 2amp? So the timer takes the load? So connect the new one up and just leave on continuous on the timer and let the stat do all the switching? Definitely compatible? Thanks

Hi I have that wall stat (2 wires) on my apollo boiler marked Myson Apollo 15/30 30/50 40 50/65 ? The timer is a Smiths? TS300/S/T/A I wanted something that would be programmable and so looked at a Horstmann DRT2 Programmable Digital Room Thermostat would this be suitable? or could you...

I notice that some fill them with stones

Forgot to say its a plastic shed with a plastic base - keter