Search results

1David Bowie 2.Ian dury- not only a distinct voice, but an excellent player of words 3 Freddie Mercury 4 Terry Hall -The specials

Used to fit the Broags, but as some of you are aware, i had a spat with Broag reference to a warranty claim I had and they gave sod all back up, so no longer have anything to do with them. I have had 2 straight out of the box,that kept blowing the fuse when it fired up, turned out to be the...

Ditto the above TBH if the boiler is not broken, and you are happy with gas consumption etc, then use the old adage"if its not broke dont fix it" Maybe get it converted to fully pumped,and add a cylinder stat(if you hav not got one), to make the system a bit more efficient. New pump and...

That pressure drop,is quite good. When I say that I mean it is not dropping rapidly. The fact that it is not dropping quickly, says that there is obviously not a bad leak anywhere, but maybe just a little. Check all radiator valve heads, they quite often weep around the gland nut, and check...

Paul My advice fwiw: Keep the combi and run just the kitchen hot water off of it. Install an unvented cylinder to work in conjunction with the combi. Bite the bullet and upgrade the incoming mains. Out of interest what was the dynamic pressure of the incoming water? Graham

How big is the system? How many rads? That is quite a big output boiler. Had similar before, and adjusting the heatload, via the d0 code, did the trick Graham

Whilst terminating it into the open sink temporarily is OK to get you out of trouble, it is not ideal. Instead tee the condensate into the waste pipe from the sink unit. Was the sink there before the boiler was installed? I have seen so many where an internal termination is achievable...

Personally I would up the size to 32mm or better still 40mm. Graham

Try PTS or HPS. Graham

Did you get any water near the PCB when you changed the diaphragm?

Double check your central heating control. S30 means that no demand from external controls. What programmer is it? Graham

Fit a Vrt 30 thermostat, in conjunction with a timeswitch 130, which is a basic 24hr pin type clock. Can be used on timed or constant. Graham

Sounds about right to me. Graham

All you can fit these days are condensing boilers. Personal choice, in no particular order: Worcester, Vaillant, Broag Remeha Graham

If your mate and his mate can do the work, why are you on here for!

What type of system do you have? If it is an open vent or sealed traditional system with a hot water cylinder, then you take the feed to the rad, from the secondary circuit that heats the hot water cylinder. Very handy to have, as when you are heating your cylinder, you ccan also be drying...

Steve The ecotec 428 is a heat only boiler designed to be used with a hot water cylinder. Graham

:lol: :lol: :lol: :lol:

Try Here: http://manuals.aonly.com/index.php?d=Boilers Graham

The only thing that you might need to watch, is the location of the gas coming into the appliance.Some are bottom left, bottom right,top left, top right. Obviously if your gas point is low down on the right, then an appliance with gas feed on top left might have the flexi stretching :shock...