Search results

Hi, Apologies for what may seem like a simple question to those in the know! I have just had a new Carpet fitted and suprise, suprise, the door is now unable to open / close without real force. So I am guessing the door needs to be planed. However, When the door is open, it needs >10mm...

Thanks for the replies! Peter, Unfortunately, I have no Welder. But Thanks any way. Mursal, I have the nut about 3/4 of the way off, so no room for the grips. I have tried the Torque bit idea, except I applied the heat to the Torque bit. So I will try as you suggest with the heat on...

Hi, I have been changing out the Compliance bushings on my car. I have completed the Drivers side without to much of an issue. However, I am now on with the Far side and having a bit of trouble. Attached to the 'Wish Bone' there is a Rod Stabiliser. This is bolted on using those allan head...

Hi, This is a post following on from my previous post about the Nabis Elixer Mono Bath Tap. I am needing to buy some Flexible tap connectors for this tap, however I can only seem to find 10 or 12mm X 15mm. Believe it or not, this model of Tap appears to be M15 x 15mm! Has anyone ever...

I know what you mean! Thanks for the replies, I'll try a local merchant like you say. Cheers

Hi, I have a problem with a Nabis Elixer Mono Bath Tap. Whilst trying to install the Tap I knackered one of the supplied pipes (with the screwed fitting for the Tap). Now I need to replace it! However, I cannot seem to find the exact size of thread required. Ideally I would replace...

Looks like a tile cutter it is then! Nevermind it was worth the thought. Thanks for all your suggestions, its much appreciated! Dave

Ive never really looked at an "Overhead type" Tile Cutter before. But was looking at this type http://www.machinemart.co.uk/shop/product/details/etc180-500w-electric-tile-cutter-230v This looks just the same as a Tablesaw for wood. So was wandering if you could get one with...

Hi, I am looking to buy a Tile Cutter, and while the usual ones I see in B&Q etc would do the Job, I kinda begrudge forking out all that money for a Power tool I will seldom use. However, if I could buy a Table saw (which I would use) then is it possible to buy "diamond Tip" Blades for...

Cheers Sparkticus, The MCB that the cable will feed is 16A so 2.5mm should be ok. The Cable length will be approximately 3m (max). And the internal wiring of the panel which the cable feeds (from the other side of the MCB) is 2.5mm. The Terminals I intend to use are SAK10 type terminals...

Hi, I have a 10mm (3 core) cable that will be pulled backfrom it's existing termination and re terminated into a JB. Within the JB will obviously be 10mm Terminals. The loading of the cable is such that a 2.5mm cable would have been sufficient, however due to the length of run 10mm has...

I recently posted a question about reslating my Roof due to the slating being done incorrectly. I am really gratefull for the response and am going to start ASAP. However I have began to wonder about the overall construction of the roof. I am slightly concerned about how the Trusses are...

Trusses question

Thanks for that. It looks like a really nice Job you've done there! Hopefully I can make my Garage just as good! allthough Im still undecided wether to go for the Lathe or not. Thanks again

Thanks for your replies. I guess it would be easier to fit them directly onto the Sarking. What would you do?