Search results

Dear Burnerman Many thanks for your and all the other help. I will certainly go over all the steps to ensure I have not missed anything and will work thru the Haynes Manual to see if it sheds any light. Throttle Body has only done 40,000 miles would it go at that Mileage? Also the RPM's...

Hi Burnerman No, No Black smoke at all. Sometimes the car Idles smoothly say for 5 Minutes and then start jerking / juddering when say stopped at traffic lights etc!

Hi All Replaced the temperature sensor but Engine still idles poorly! Have run out of ideas now! Anybody have any other views or suggestions as to what the problem(s) is? Many thanks.

Hi Spark Plugs and Leads have been replaced. Car is lumpy when parked on an incline without even driving up it.

Hi The only one I could find was at the bottom of the radiator. When car was shaking I took the wired connector off to see if it did make a difference but no nothing happened. car still continued to shake. Is it worthwhile replacing this sensor if disconnecting it made no difference? Many thanks.

Hi All Will certainly try the temperature sensor, is this the one located at the bottom of the Radiator? also another puzzling thing i noticed was that the car shakes when on an upward incline!

Hi Yes I have cleaned the Throttle Body twice and each time taking great care to clean it meticulously. When I restart the engine it runs smooth but after a few miles when its warmed up to operating temperature the Engine idles poorly and shakes very badly.

Hi Yes checked all the hoses including Servo Pipe to throttle body each one is fine. When I broken the Servo pipe seal the pressure was released as expected. I even cleaned out the EGR Valve just in case but problem is still there! Renewed Throttle body gaskets as well just in case!

No Fault Codes indicated as car was plugged into diags machine, Idle steady at 900 RPM but engine rocks backwards and forward really badly shaking the whole car! Not sure if this car has an Idle Control Valve? If so where abouts is it located?

Dear All I have a VW Golf 1.4 16 Valve 2001 Reg. The Car is suffereing from Poor / Lumpy idling when Hot. When the car is cold the idling is fine and the engine runs smoothly till it gets hot and then sometimes it idles smoothly sometime not! Steps taken, Replaced HT Plug Leads, Spark...

Hi All My Thanks to all, just an update, left heating system alone for 1 night, next morning fired up boiler and surely but steadily heating came on although had to bleed both upstairs and downstairs radiators so certainly looked like blocked cold feed pipe and air lock problem! Some...

Hi NealDean That is the thing that when upstairs Radiators were working and were then shut by closing one valve on each Radiator to pass the flow of heat to the downstairs radiators that was when the boiler locked out I think!

Hi All Anybody know what the problem maybe as now the upstairs radiators which I managed to get going by refilling the system will not work anymore! Therefore upstairs and downstairs Radiators do not work! Hot water is OK and Pump appears to be working although a little hot! Many thanks.

Hi Seco Services / coytech Many thanks for your replies. If I shut down the upstair Radiators the Boiler shuts down! Could this indicate an Airlock or a blockage? Before the upstairs Radiators had no water or pressure but since dismantling the pump and cleaning out the Cold Feed Pipe the...

Hi All Sorry about the long post but really need help!!! Had a chap put some inhibitor into system Fernox MB1 via Upstairs and downstair radiator. Then upstairs radiators would not heat up no pressure or water from then when being bled. Boiler engineer advised boiler is fine and that Cold...

Hi Zipper Many thanks for the reply my Guess is that its the PCB Board as there are no Panel lights anywhere but power button does work. Water Enters the machine but guess is it goes straight out as when you lean the machine forward there is none in the pan, tablet is not dispensed. Will also...

Hi Zipper The dishwasher has 2 Buttons Left Hand side Power and Timer delay with main LED above them which shows time etc. To the right of the open handle are 6 Buttons and LED's The Machine motor makes a whirring noise just like it is functioning normally, spray arms rotate as usual and...

HI All Does anybody know what the problem maybe, desperate to learn what the problem maybe and solution? Many thanks in advance.

Hi Zipper The Model is SGS6612 GB/07 and water does enter the dishwasher as whe you open the door the spray arms are trailing water on to the plates etc. Whirring noise seems to be the motor? No lights on the Panel at all

Hi All I have a Bosch Logixx Dishwasher which has been running for a few years without problems. This morning I discovered that the Dishwasher control panel has no lights although when power on something is whirring away and water is entering the machine! Anyone know what the problem is? Many...