Search results

I would just plaster over it and if in the future a new gas line is required it should be installed from scratch

You dont have a F&E tank. Buy the inhibitor you administer through the rad bleed nipple.

Boabyboy wrote "HIYA, DOES ANY1 KNOW THE PROCEDURES FOR THE CCN SOUNDNESS TEST" Oooooh are you gonna get some stick :!: :!: :!: :!: :!:

Yes :lol:

Read your first reply to this post. Cant figure out how to use the quote facility.

What type of system will be supplying the hot water ?

|Do you think he'll bite then Bahco :lol: :lol: :lol:

softie wrote "The installer is not the home owner, therefore he would have to be CORGI registered in order to legally install the appliance " What makes you assume i'm not CORGI registered :?:

Ooooooooh i've started summit here, i know this is a DIY site but as ive installed at least 500 boilers and never noticed this pressure fluctuation before (wether it happened or not, i've never noticed it) i came in from work, posted this question then went out and got really drunk (try it...

Yeah i did do it myself (not really there was two of us) i was only asking for a bit of advice :roll: if i want sarky comments i'll speak to her indoors

Installed a Main 24 he today, commisioned it and everythings ok. While showing the homeowner how to use it someone turned the hot tap on upstairs and i noticed the pressure dial went up by half a bar, when the tap was closed it went back to 1.5 bar (CH had been on for a ten mins) ive never...

[I did consider it might be gas forming in the system, but due to the lack of any iron in the system to corroad , i thought it unlikely,] Whats your radiators made of then :D :D :D

Thanks for the help lads, much appreciated.

Hi, i'm a plumber on a long contract installing combi boilers and would like to get into fault finding and repairing them (knees starting to crumble) i know its gonna take a while training etc but can anyone recomend a good book or website showing how to use a multimeter (i basically know about...

Cheers kevplumb, how come it works with both taps open (is this due to the extra water rate being drawn ?)

Hi, when i open the kitchen tap on my vaillant turbomax 242 the boiler does'nt fire up, if i leave this tap on and open the basin tap it comes on, could this be the flowswitch or possibly diverter diaphragm or just filters needing cleaning, P.S. heating ok

Fitted a new combi today existing cooker pipework was 15mm chrome soldered to yorkshire elbows, pipework tested ok but never came accross chrome soldered on a cooker pipe before, as i was the last one to touch the gas is it ok to leave this chrome in or should it be replaced :?: By the way i...

Or better still show your dad how easy it is to re-pressurise the system, (his installer should have already explained this by the way) and dont forget to disconnect the filling loop when your done.

I know this may seem trivial (compared to all the other obvious mistakes) but the gaspipe outside should have been protected from the weather i.e. plastic coated tube or denzo tape. Hope you get it sorted soon mate.

If its 22mm it needs lagging, use colour co-ordinated cable ties they wont come off.