Search results

So I could use one 45a dual appliance outlet send one of the cables to a dual box and plug the ovens to each of those sockets (basically a double socket I presume) and then send the other cable to the induction hob or a single socket for the hob. I also presume 6mm cable for the hob but is 4mm...

Just watched a video on Diversity and doing the calculations using the following and allowing for an additional socket at 5A I get a total of 29.94Amps. @240v and 30.72@ 230v First oven 3.45kw Second Oven 3.45kw Induction Hob 7.45kw total is 14.35kw 14350 divide by 240v = 59.8Amps (Using...

Morning All, We are in the process of replacing our kitchen and on the new design we are replacing our siemens 1 and a half oven with two neff single ovens that have an output of 3.45kw B47CR32NOB model number, we are also looking to replace our gas hob with an induction hob that produces an...

I’m lucky I have hard wired access to the garage already so happy days.

Hey all, loads of great information on this thread which I know will not only help me, but also others with similar questions. just wanted to thank you all and keep the help and advice coming. the Anderson A2 is a great unit with plenty of optional safety features available however as with...

These were attached when the the upgraded cu was installed. I will adjust the stickers so there is no confusion.

Hi guys thanks for all the information, a few of you are talking about looped or not looped, we are not looped and I have contacted our DNO and they are happy to also upgrade for free our current 80amp fuse to 100amp. The 6mm cable coming from the house consumer unit to the garage is approx 15m-...

Thanks for your quick reply ericmark I would do as you suggest.

Evening all, I am looking to install a 7kw Ev charger and just wanted to know if this is possible with the current setup I have. The house is just over three years old and the garage cu currently has the usual 2 rcd 1 16a and 1 6a. The cable feeding this is a 6mm 3 core cable which I believe...

Ok so the yellow wire that is currently in the common of Z5 will now go into TR and the white and the original TR are not put together in a connector block. I think I have it. I presume to test if it works with the resister I will need to take the new bell box cover off to see if the tamper works.

Ok so basically take out the white wire in Z6 and put that in the Tr original and just to clarify also the yellow wire currently in common on Z5 and also add that to the Tr so in total three wires in the original TR. You mentioned I may have to remove the resister. What would be the reason for...

That’s a bit naughty, how would another company ever enter the engineers menu if they changed the code. Just a way of always being tied to them. Genius.

ok I could do that but just to confirm my current wiring. I have installed a 2.2k resister at the new bell location and put this wire into Z6 (white) then I have the second tamper wire coming from the new bell location into the Z5 common and then have wired the new bell up to the 0v and 12v next...

Evening all, well I’m the new additional bell is up and running however and there is always a however. Loll. I can’t access the engineer menu to change zone 6 to 24 hour program as suggested by you guys. I have tried code 1111 but nothing happens. Allow engineer menu is set to yes in manager...

:):) Thanks

Site record

Ok I have attached a couple of pictures of my control panel, and as you suggested z6 is available so happy days. You said program this to 24hours is that correct.

I will let you know how I get on with them, as long as they do what they say on the tin I will be happy.

Did have a cat, treated the house like a bed and breakfast. Great life.