Search results

Thanks for thr information, much appreciated. Additionally I refelted the garage room in 2005, but I assume thaat is classed as maintenance though?

When I moved into my property in 2000 the rotting wooden porch was replaced on the front with an identical one but used PVC cladding instead of wood. The porch is behind the building line. The windows were also replaced with PVC also in 2000. No planning applications were made. The buyers...

I have a WD145 integrated dishwasher. The salt sensor light can on the other day but I did not have any salt. I used a tub of ordinary table salt thinking this might work but no. I bought some proper salt and filled the container. The salt light now shows nothing and the washer bleeps for...

Sorry, I completely forgot! Matsui MF145/A. Slimline built in. It fills and circulates water for 5 mins but it cold then stops. Steve

I have a slimline built in dishwasher which is around two years old. The unit will fill and run for about 10 minutes and then stop. I suspected the outlet pump was faulty? I have tested across the terminals and there is a continuous circuit. I have not been adding salt to the washer...

Hi I replaced a mixer cartridge and after being away for three days the tap has gone really stiff....just like the one I replaced. Has anyone else had this problem, please? Have I fitted it incorrectly? I removed the old one instered the new cartridge screwed on the retainer (not too...

Yes I have seen. I know its 40mm and I will take the old one with me. Glad I fitted isolation valves when doing the bathroom so I can use water in the rest of the house. S

OK thanks for the fast response. I notice they arent too expensive just need to get the right size etc. Off to the plumbers merchant in the morning.... Steve

I have got the cartridge out and taken it apart. the only part that is stiff is the hinge at the top with a spindle through it. Could theis be bought seperatly or would I have to replace the whole lot? Steve

Do I have to replace the cartridge or can it be lubricated?

My bathroom mixer tap has become very stiff recently. I read in a forum some while back the usung silicone spray might ease the movement. However it does not. I have managed to remove the top and find a large nut ... how you get a spanner on this is gonna be difficult unless there is some...

tap

The hinge has now broken where it meets the seat. The saet works fine now but the lid is loose. It was from Wickes not B&Q and was over a year so is out of guarantee. The seat is in perfect order and replacement is £37+. Wickes are unable to advise me where to get replacement hinges. Are...

The two hinges of my soft close seat have started to shed their 'chrome' coating. Bits flake off every day. The seat has only been fitted about 12 months. i think it was from B&Q or wickes but I dont have any receipt...and they would say its wear and tear anyway. Does anyone supply these...

WOW!... now thats cheap.....all I need is the rubber seal! The fact that they are sold in two's worries me....they MUST be prone to failure of the seal...why dont they just sell the seal????? Saw these at DIY store...but was trying to avoid removing the cistern. I will probably go that...

Hi I have a pacific flush valve which is allowing water to seep into the toilet bowl...not a lot be with maters on the vater its annoying. Today it seems worse...the cistern 'tops up' avery few minutes. I have had a look and the bottom seal was is dirty ...I cleaned it but it still seeps...

Yes it was off all day today and still had same problem tonight :-( Any advice on where to get spares?

Hi I have an F2 flashing in display. (Manual says Air Fault...check air switch of Fan) The fan does not start and testing with a multimeter shows no power at fan. Wiring checks out ok back to circuit board. Anyone come across this before....does it mean a replacement circuit board...

Still cant find any supplier who lists part no 801910. Has it been upgraded again? Thanks