Search results

Would it be worth disabling EN & PD options from the keypad (rather than wintex which I've already tried)? Hang on, I'll give it a try...

Short vid of what's happening

Just checked all the options on the wired remote keypad (only keypad). EN & PD both enabled and grade 2 also enabled (doesn't have a specific grade 2 option in Wintex but strangely does on the keypad??) So I'm at a complete loss as to why the part-armed banner doesn't stick. Can you try...

It is unticked but part-arm banner still makes way for normal banner. If I could attach a brief 20sec video I would but don't think I can?

I've set the guard attribute for both the front and back door contact sensors (they are entry/exit 1 for front door and entry/exit 2 for back door. This way instant alarm when part-set at night but entry/exit on full arm.

SUCCESS!! Control timer does disarm my part-set. Result! However, although it's not possible to arm the part set with a control timer, this doesn't matter so much because I just wanted to ensure the missus didn't forget to disarm in the morning and set the alarm off. Don't need to worry about...

Option 37 looks like it's already set to grade 2 by not being ticked. Grade 3 if ticked so presumably grade 2 unticked?

Thanks secureiam, So both those on no probs but where is the option to set to grade 2? Don't remember seeing such an option but then again, I wasn't looking for it before. My firmware is v5.02 btw.

Yes, but I've tried it off (sent to panel from wintex) and it didn't help.

Here's my config. PD6662 showing on but I've tried it off and makes no difference.

PD and EN both off

No Texecom connect Version 5.02 firmware Yes, spare zones on both keypad (2) and zones 2 to 8 spare in panel I thought a control timer disarm will only disarm a full set, not a part set? I'm not too bothered about a timed arm, it's more a timed disarm (from part-set).

Yes, that and PD6660

Hi, yes tried that too. No luck.

Yep, tried that. No joy. Still reverts back to normal banner text after a few secs. I need the *part armed* banner to remain on display until the system is unset. Not just for a few seconds when the system initially sets. Also tried removing the normal banner text but that just returns a blank...

Pulling my hair out over this and can't figure it out. When I part-arm the system (texecom premier elite 64W) the * part armed * banner appears on top line of keypad display (great, this is what I want), however after a short period of say 10 secs it is replaced with the normal (alarm unset)...

Hi Is it possible using control timers to have the system part arm/disarm at specific times/days? I know control timers can fully arm/disarm the system but can you do the same for part-arming? I want to auto part arm 1 (I only have 1 part arm set up) at midnight every night and disarm at 6am...