Search results

Greetings, I need to match these bricks to brick up a door. Any ideas what they are? The original building they're matching goes back to 1903, the bricks are quite soft you can groove ridge with your fingernail if you do it hard enough. Unfortunately I don't have a loose one to get a proper...

You can buy the Texecom RM8 relay module and use the relays on that to mirror zones or other functions of the panel (e.g. when armed or in alarm state). These outputs can be used for arduino/pi. I use it myself to incorporate the alarm into my zwave system (not using arduino or pi), so I can...

Hi Ian, yes I realised that, my rambling above was about afterwards! Thanks again for your contribution

Thank you all so much for your help with this what great feedback, thanks for taking the time. An update: I removed the screw, turned the impeller (with power off to start with), it didn't seem jammed but the water that dripped out as I did was dirty, once power was applied it whirred away and...

Thanks folks, I'll give it a try and keep you posted. In the event of complete pump failure/seizure would it swap out with this one: https://www.screwfix.com/p/wilo-yonos-pico-25-1-5-130-glandless-circulating-pump-230v/3080x

Thanks for your reply, no haven't tried spinning the impeller. I have had a multimeter on it and confirm that it's receiving power, but aside from slight buzzing there's no sign of life. I'll have to try the impeller spinning, thanks. How do you find out what head the pump is driving? Thanks...

Hi there, My heating pump has stopped working. I'm not 100% sure what to replace it with as the model is discontinued, I'm looking here: https://www.screwfix.com/c/heating-plumbing/pumps/cat5170016 Any suggestions as to best replacement? Here is a pic of the current model:

Thanks @sparkymarka , that was it, I changed the setting this morning and all now works as expected. Couldn't see the wood for the trees!!

Apologies, it was better spaced out when I typed it! The A & B refer to the terminals on the smoke detector. Here’s the photo of the smoke: here’s the panel: The tamper terminals are linked together with the white wire.

Hello, I have an Elite 48 setup with working PIR zones which are wired EOL. I have 2 zones which are Fire zones connected each to a Texecom 4W smoke detector. My current wiring is: Panel Smoke detector Zone A (N/C) Zone B Com. The...

Cheers Ian. I had a feeling it was heading that way!! Thank you both for your help.

Thanks for your reply. I have opened the combustion chamber and here is a pic of inside (complete with dripping water as can be seen in the middle), I'm guessing this is bad news! So would it be sensible to go down the fixed price repair from Baxi direct do you think?

Hi there, I have a Baxi Solo 18HE, it is leaking water, upon case removal it is dripping from the end of the venturi. Is this likely to be the heat exchanger? It was installed Jan 2012. Just wondering about the fixed price repair from baxi, but would be a waste if it's something simple...