Search results

Remove lid ,fan and fan motor sited rear right of machine.Take small elastic drive belt off run on dry cycle to identify noise from fan or from fan motor.Good machine worth saving

Adding to tiredengineers reply-if tracks on timer blown also check for hole in door seal,water gets on to door lock and blows timer

Electric hob should be connected to a cooker control unit using 6mm twin & earth cable, use the earth conductor of this cable,no further earth required. You should realy test the earth at the ccu but you need special instrument to do so.

Hot fill valve

If this is a condenser drier you will find a 7 micro-farad capacitor by removing rh side panel

There used to be a kit to fit to Lecs-this came in the form of a sensor that switched fridge lamp on to raise internal temp of fridge to overcome low ambient lockout that you describe-dont know if still available

Dont know specific model but if pump running all time suggests leak into base of appliance,usually panel to remove to inspect base-dry out run and look for leak

If this is an auto defrost fridge-check tray on top of compressor for food debris in water ,if this is the case make sure things in fridge dont touch back wall of fridge in future

Open oven door look for 2 or 4 screws (usually coloured black) that screw into cabinet remove and slide oven out

sounds like door interlock-there are two types on lexus,3 and 4 terminals check b4 buying

ta for info-ive sorted problem now ta again

Trouble with combustion door seals on some of these causing explosive ignition-call Corgi in to investigate

Sorry should have been clearer-Im an electrician whos also ACS qualified and Corgi registered

Can anyone help with wiring diagram for Electrolux Gas oven Model E)G7330wn,pnc 944201088. I suspect grill overheat stat but three connections to stat,dont want to short out till loooked at wiring diag .

Try a search on a product called Teleseal-available thro screwfix amongst others.Tiles etc tend to leak after a while

sounds as though this model has a sealed base which is full of water due to a leak, this operates a float switch that disables machine but brings pump on

I think its bolted to metal crossmember at top of machine under lid

Corgigazza-with solenoid connected to pcb(grey plug) boiler goes thro start up procedure but trips main rcd, disconnect solenoid from pcb boiler goes thro start up procedure but goes to lock out after 10 secs of spark.Will let you know if im wrong.Nige

Thanks chrisr,cant ask for a quicker reply

Cant find GC number for this boiler-gas valve solenoid down to earth need to get back to cust with price,is solenoid available separately,does anybody have manual or part numbers ta in advance