Search results

Loft pic All pipes elbow to the left like I mentioned earlier. Sorry what do you mean here polesapart? I put my finger over the mixer tap hole and turned the hot on whilst I then slowly turned it to cold, I think it's made a difference not spluttering as much now - mainly the bath mixer...

No not altered it too much, slightly yes as seen in the other pic earlier. I'll get a pic up later, in work at the moment but basically it goes straight up then left via a elbow. I have slightly altered the pipe above the hw cylinder as can be seen in the pics I posted earlier. I did want to...

Mrs ran a bath so yeah been on for a minute or two as for the PTFE I had a small drip from them so I re did them and decided to add a little PTFE to make sure, no issues now touch wood.

That dont help much but thanks anyway! Slept well thanks! Checked it this morning and its worse at the bath mixer taps, other taps are not too bad to be honest. Im currently at work so will have another look when I get chance. If I was to swap the hot and cold deed on my washing machine...

If I was to loosen, well take off the stop end would that do the job do you think? just getting desperate here! I'll bump this again when I get chance to have a 'mess' with it, off to bed now - thanks for the suggestions by the way.

I would BUT it's not connected up yet to any pipes! it's sat there waiting to be hooked up (once I've run the feed from the cold tank in) I am sort of hoping once I connect the pump up fully etc it will go away although I think I'll be sadly mistaken.

I think it could be air myself but haven't a clue where from unless it's to do with the pushfit stop end, really struggling with this one. Cold supply seems fine, no issues there.

It was originally like this but I never had an issue with spluttering and it's not that different really.

Border line minimum height I'll admit but I'm hopefully replacing the tank in the near future.

Yes, it is the opposite on a Warix flange according to the install instructions - Surrey is the way you describe Doggit.

Top feed is for the shower pump which I havent finished the pipe work to - got to run a inlet feed from the Cold water tank yet. Plan is to connect the hot up then. I have done the pipework to the bathroom - thats the two copper pipes to the left (outlets)

Gate valve is fully open there picasso, do you or anyone else think this issue will go away once I remove the speedfit stop end and then connect all the remaining pipework up to the shower pump? It's very annoying as I thought I'd done a decent job so far.

Normally is on other Flanges ie Surrey but NOT on a Warix that is one schoolboy error I avoided!

Evening all. I am in the process of fitting a power shower and have adapted the pipework slightly in order for the Warix flange to fit but since doing this the hot water is spluttering from the taps :( Any ideas? I havent yet finished the install to the pump (speedfit stop end on as a temp...

Hi stevethespreader, Joists run across but can't be seen on pic, they are holding the ceiling up honest! I am going to sleep on the options, thanks for the tips. I've done some digging on the the texture front and people have used joint compound to good effect, may try that. Easi fill a...

Cheers, bigger job than I had in mind that!! It hasn't, just maybe looks it from pic. Joists and a few noggins are supporting the ceiling where needed.

I take it no one knows! I'll rip the rest down then and hopefully that will sort it. If anyone can help with the ceiling texture match please feel free...

Anyone help us out here. Ceiling had a leak, I have replaced the Plasterboard but it doesn't match up with existing plasterboard :( Gap is this at the most. Solutions please? Final thing, how do I get the same texture on the new part? old had like a raised speckly paint texture. p.s I...

This. I just done this, looks miles better and easy to do.