Search results

If you can hear the compressor running and its not getting cold at all then it isn't going to be the thermostat it sound's like it has a system fault (To do with the pipework ie blockage or leak) or the compressor has become weak either way it wouldn't be worth fixing :( .

The fan in the freezer has failed . On these American style fridge/freezers the air is circulated in a clockwise fashion.

Cheers jock :)

It seem's some rich aussie has formed the blue star line and is building an exact replica albeit with some safety improvement's but is it all just a pipe dream????. You'll have to google blue star line cause I'm cr4p at link's Ahem unless someone could help me out!! :oops:

It's only Stove's/New world that do built in gas now so your limited to them. I personally much prefer gas over electric though and as gas is what your used to you need to stick with it.

Could be the main motor isn't turning as fast as it should. They do have a water counter fitted but when this fail's it usually half fill's with water and then just sit's there doing nothing.

Will either be the water counter or the circuit board.

There's a knack well mainly down to experience really to using the crimping tool for the lokring's if you crimp too fast or don't have the jaw's aligned properly then you can snap the lokring so my opinion is it was the engineer.

It's detecting a fault with itself it could be the motor brushe's or anything really :(

Most likely the main PCB in that case the machine will only spin a balanced load and I've known the circuit boards to become over sensitive on these.

You can get a wiring diagram covering the entire machine but not just the board itself but I can tell you E51 is specifically pointing to the motor relay on the board . Your local tv repair shop maybe able to repair the board for you and quick look down the tip might uncover an identical machine.

I'm guessing you tipped it over to the right and now water left in the detergent compartment has gone onto the main PCB on the right hand side . Sorry mate but its a classic error . You need to replace the main PCB .

I'm on O2 and the last few month's my phone signal keep's either dropping out altogether or drop's to one or two bar . I've an iphone 4 and I hadn't updated it in age's so I updated it to the lastest IOS7 update and what a mistake that was I think it's shoite but it made no difference but since...

Mike ok god's the creator then but who ffs created god something in your logic would of had too anyway it's Halloween and I've just seen the first two witch's fly past the moon on their broomstick's :lol:

Proberley the door hinges are worn so the door isn't quite sealing the wall at the back will just be from the oven vent I would think so that would be normal.

The pump is accessed from the front you just need to remove the front kickplate and the metal panel behind it and the pump twist's off but are you sure the installation isn't blocked at some point??

The capacitor is easy to replace but from what you say a blown pcb is not good news it could well be the motor's blown the board maybe time to replace the machine.

It could well of been the motor capacitor that has become weak they were common to go on them as for the circuit boards they fitted quite a few different versions so it could be you've been given a wrong version as they appear identical looking at them.

I carn't recall jesus wanting to start a "jihad" so I reckon bin laden may of fooked up his chance's!! :lol: :lol:

If you have a supply for sure to the machine then it isn't going to be the drying element if there's no display it could be the pcb or something has blown the pcb or is causing a low insulation problem causing your RCD to trip . If your unsure then you need a proper engineer to take a look...