Search results

Check the seal , may be perished If not try another arm http://www.casaparts.co.uk/products/id-27080925

dirty matrix take side panel off you will see a plastic water matrix top left will be grey black gunge take out and clean and then replace

circulation motor not starting either blocked - take out and clean the pipe work or more likely to have failed try these http://www.casaparts.co.uk/search.php?cat=2&subcat=&subsubcat=&cat2=1&order_by=&page=1&search=&text=

if the fan has power coming in and not running it would seem the motor has burnt out seen a couple of faults like this on these bosch simple to fit http://www.casaparts.co.uk/products/id-25120923

can you hear the circulation motor running constantly does the water heat at all

is a case of having a look at the salt box in the base of the machine. simple to replace , a tadd more tricky to get too but not much

I think these have a little sensor on the side of the salt box inside the machine. i don't think you have a major issue that will cause the machine to stop working , just a sensor which is faulty

I can only assume that the description of the fault is very poor :oops:

drum spider coming away from drum never heard of that before , let alone thought it possible without malice

that makes me more confident of my diagnosis eco washes & quick washes on dishwashers & washing machines are good for efficiency but not so good for hygiene long term :)

might be a faulty pressure switch might be gunge and similar building up give the machine about 15 litres of very hot water and a few drops of bleach let soak overnight then switch on and run a hot cycle should clean the insides out see what happens then

you can pull the pipes of the pressure switches and the connection to the sump hose could be full of brown crudd blocking the pressure switch you can take off the pressure switch and blow into the connector, you should here a click and then another click as the pressure from you blowing is...

its a thermocoupling , not for any amateur to fiddle with

need to thoroughly defrost for a couple of days. then switch on and all will be good when a door is left open ice just builds and builds

nice to hear people like to keep stuff going on :D but i think in this case you may be on a hiding to nothing here :cry: with the seal in contact with boiling water on a regular basis it is only going to be a temporary fix :oops: . by the time you have bought the glue and done...

try this for a cheaper option http://www.casaparts.co.uk/products/id-30120909

possibly filters blocked or motor brushes on way out

Its the same as cars sometimes its a lucky dip they're all good :wink: till they breakdown :D

check connections by the interference supressor, ( where cable enters the machine at the back base) but switch off first if pulled can come loose - first place to look then take the front panel off and have a look for chafing wires on the loom by the base of the door and around the soap...

when you switch on , what does the machine do i.e , does it fill , drain , heat the water , spray arms rotate etc etc