Search results

I am going to fit the above to the inside of my garage near the door as it fits into the space perfectly and take energy saving bulbs. My question is based on the instructions, I was going to connect it to the current MCB that supplies 3 outside lights as the is plenty of capacity (amp)...

Thanks all for the advice I went for extra safety and placed electrical insulation tape on the back of the steel cap and glue it to the white plastic holding the pipes in place. Also sealed the plaster board to the wood either side of the pipe. Left the hole near the pipe unsealed to allow...

any thoughts on the steel cap not touching the pipe appreaciated Chris

pictures

Bengasman Could I ask if the steel shielding does touch is this a problem. We are using silicone sealant to glue the steel shielding to the gas plastic clips that hold the pipe in place. Cheers Chris

Bengasman Thanks for your information, the joints are not compression but soldered. I will have the electrics at least 2 inches away from the gas pipe. See picutres chris [/img]

Chris Thanks very much for the diagrams. I have a question, you mentioned that the steel cap should not touch the copper pipe - Is there a reason for this. We have tested with a detector and the copper pipe on it own cannot be detected, therefore we are going to glue the steel cap to...

Thanks Chris R Do I need to do this around the horizontal pipes? Cheers Coops

Hi I am creating a small store room within my garage using plaster board that I intend to dryline to create the wall and partial division within the garage. The gas pipe is already attached to the wall. My question Is it okay to cover the gas pipe with drying lining ? I was planning to...

Covering Gas Pipe with PlasterBoard

Hi On the above washing machine after selecting the programme and pressing start, the machine starts for about 1 minute and then stops, with the lights flashing saying that the door is open. The machine has been running fine and the water supply is connected fine. I can drain the machine and...