Search results

they are to be fitted in the top wall cupboards and i need a switch lower down to work them.

Whats the best way of cutting kitchen cornice accurately, i dont want to ruin any practicing.

Ive got five low voltage downlighters to fit in our kitchen , how do i connect a switch to them(diagram please) cheers....

Hi im fitting a new kitchen and the existing sockets need to be lowered by about a foot , i cant pull any spare cable through from upstairs as they are sheathed and plastered over in the wall. Do i have to channel them out and replace the cable run or can i add a extra foot of cable and if so...

what causes a sticking startermotor,sometimes when i turn the key i just get a click from the starter and it wont turn the engien over.

ive got a n reg toyota hiace compact diesel van, having trouble getting first and second gear when stationary,ok when moving.i have to go into third or fourth then it will select first and second (if that makes sense) . Is it a gearbox or clutch problem...

We need two interior doors 80inch x 32inch, does anyone know where i could obtain these sizes, preferably near Birmingham. thanks.

Our daughter has bought a flat recently and is having trouble with the electric imersion heater. It keeps boiling and she says the cable also gets hot. Ive told her not to use it as there is obviously a fault. It doesnt trip out the fuse board so im presuming its the thermostat thats gone, is...

How do i turn off the timing belt warning light.ive had the belt changed befor the 120,000 mile time limit was reached. now that mileage has passed the warning light has come on.the vehicle is a Toyota hiace van,diesel 2.5 n reg. ive been told it has to be linked up to a diagnostic...

cheers crafty,do i just link them together with the original 32a cooker cable,your right about the one being used to ignight the gas..

just bought new oven with gas hob above,both come with three pin 13a plugs fitted, no double plug near by,can i use 32a cooker cable that was used befor and if so how. cheers

Im renovating a house which has had the outside toilet and coal store incorporated in the kitchen area. The walls are painted with emulsion or similar,can i seal them with pva then give it a coat of bonding plaster to level out the uneven brickwork,then skim. Or would it be quicker and cheaper...

I need to extend a cooker cable,as it will be to close to the hob, can i use a junction box under the bedroom floor where the cable runs. CHEERS

HI all,just had new bathroom fitted,toilet is a built in unit flush to cabinet. problem is the seat hinge has broken and the only way to get to change it is to take out the toilet,as the brackets fasten underneath. Can i get a new seat that fits without having to remove the loo every time...

HI alarman, i use johnstones supalatex emulsion,really good stuff.its on offer at stax oldbury 13.99 for 15 litre tub. or you could try johnstones them selves,middlemore rd,w.brom

Hi I have a similar problem with my Toyota hiace van,difficult selecting 1 and 2,could this be linkage wear too.??????

Ive got to strip some kitchen wallpaper and its a right pig to get off. Its that tile effect stuff that has like a plastic coaing on the surface. It only comes off in little inch squares. Any idea's please.

Sounds like youve got old distemper paint on your ceiling ,which dries white and powdery.It is very hard work to wash off,but try and remove as much as you can with warm soapy water.When dry seal with PVA or better still masonry stableliser solution.Leave 24 hrs then paint over .If that doesnt...

Thanks for all your replies,I undercoated the ceiling today and it seems OK...

Whats the quickest and cheapest way to seal a lounge ceiling approx 20' x 10' it is nicotine stained and emulsion will not cover. I usually give it a coat of oil based undercoat ,do any of you know a better way.....