Search results

Sham, how much did you pay?

not seen that bit, but dont tell me, i bet its only them who sell them?

it was coming up kev from the ground, but after i collared the flats maintenance dept, it turns out the whole block had 1 big tank on roof between them all, as this blokes was on top floor it wasnt good enough.... on a bit of a different note, the whole block of flats had no gas supply to it at all

I fitted an electric shower the other day in a block of flats (10th floor). As usual i came off the mains(at least me and customer thought this) Pressure seemed fine...installed shower, low pressure reading. After a bit of problem solving, it turns out the flats have 2 mains coming into them...

Im comfortable with all tests, but got no stuff myself. Im on 16th edition course the end of this month, thought i would get it out of way before i start 2360 pt2 in sep... I have been reading niceic website again about registering, and its still not all black and white to me, charges for...

To get part p from niceic you have to demonstrate ability for testing, does this mean i need 2391 plus all 16th edition testing equipment?

Simple, If he has a moustache send him packing

Thanks for replies, now their is a certain building inspector were i live who really should be on this forum himself, i put a wall mounted switch in airing cupboard, and he reckons (i wasnt there at time, he told customer) that it shouldnt be there, he said there was changes made in february...

The quote was from Mike Lawrence wiring systems, he has a little section on wiring regulations, now i have just been flicking through the regs and i cannot find the quote, i use mainly brian scaddans book on the regs, and the OSG,....forgive me for critisising the sparky bible, but the book...

(REGARDING SHOWER INSTALLATION) a wall mounted switch can be used instead so long as it is at least 2.5m (8ft 3in) away from both the shower and the bath (it can be within 600mm - 2ft- of the closed sides of a shower cubicle in a room without a bath) or else is situated outside the room where...

1: DO YOU INTEND LIVING THEIR? 2: DO YOU INTEND USING COMMON SENSE? 3: DO YOU WANT A REPLY OFF BAN ALL SHEDS?

Soz ban, forgot to mention, he also wanted a double socket in case anything else decides to go in the shed

yep i was being lazyass not looking, had hard day....so i deserved that...duhhh

just a quick one, hope its not to daft a question... whats the difference between jacuzzi and whirlpool bath?

its not ideal, but you can always run it in trunking and seal it with sillicon

if you have done them 2 courses you should be surrounded by more than enough literature to cover 2391 and 2381....if not though, just go to amazon books and do a search for brian scaddan, everything you will need

Seen a few sketchy instructions about installing power showers. Am i right to assume that they are run off seperate hot and cold water feeds fed from the tank. Are run off a switched fused spare on a 3amp fuse. Is it possible to take the water straight from the mains?

up my neck of the woods harrym we have just taps outside, so anybody can turn them off

well for one, he had no rcd protection in very old fusebox, not even a spare way for the new radial circuit, 2, you had to come from the front of a very big house to meet swa in rear, you had to get cable over a paved area, and then your faced with a wall to get cable over/under/through... next...

went down to that job today... He actually thought i could take a spare from the ring and run it about 25 metres to shed, buried in a shallow channel in garden, even though he said he wants power to feed pondpump and a birdbath (yes i thought that as well).