Search results

Ok thanks for your help, will not be tiling with such large tiles, have texted the customer explaining they could do with picking a different tile, also the fact that there will only be 2 and a bit tiles per row will possibly give a smaller area feel, but at least I can see the weigth limit on...

i agree, but when you say they cant be stuck to plaster walls, what would be the solution with the walls, as i normally go on plaster altho never done tiles this size,

im a plumber/gas enginner, i also do a little bit of tiling and im not bad just slow, my problem is some friends bathroom i will be doing in the next few weeks needs tiling, the area is a 800x1400 shower tray, i,ve done full bathrooms before but this one as 300x600 tiles and they want brick...

yer i will check again and talk to technical see what they say

been to look at a saunier duval, semia condens, with 21 flashing, the pressure is ok, when you call for hot water or heating the pump runs but have no power to the fan, i've made the pressure swicth and theres no attempt for it to try and light, will ring technical support in the morning, but...

Will try that in the morning, also gonna ring Glowworm technical, bit worried because its showing 1.8 but ain pre heating

Working on a cxi ultracom 24, my problem is the fault f9, I have 1.8 bar showing when I reset it, when the boiler starts up again Im sure I hear the divert vavle motor back and fore, but the fan does not run for the pre heat, after about a minute I get f9, had a faulty pump onces before and the...

Looking to get my self some insurance as this is something I need, unsure what the different is between public liability or just liability, or are they the same, many thanks

Maybe a Blocked cold feed. That's why the radiator not fillin, time to call a plumber at lease he will fix it and problem solved

Increase the pressure to 1.5 when cold also the fact that the bottom of the rad is hot says theres air in the radiator have these rads ever worked could be air locked

yes gas registered, its only 3 years old they have a cast aluminium heat exchanger not the old cast iron one, which is why a fort it needed pump over run, turn boiler temp down it had been running for a while while i analyse guessing it was up to temp,

could try getting a service call, did the installers have any ideas seems odd

serviced a ideal mexico floor standing boiler today, it was ketteling when working sounded like the the heat exchanger was scaled, when i turned the temp down to stop the boiler working the pump stopped, read the manual and theres nothing about pump over run, does this boiler need it, tried...

my mistake flexicom is 390mm not 380mm plus 5mm each side

the glowworm flexicom will fit, as said they had a problem with the hose on the heat exchanger splitting, but glowworm have great back up service next day most times, had a service call on a ideal once, 7 days later they arrived, by which point i fixed it myself looks good with the customer when...

i would suggest removing the liner and having a cap put on the chimney these have vent holes and prevent rain from entering, gas safe enginner should advised and help,

Did you have your yearly service done and bench mark book filled in

It may seem strange but must be black

Flame port Also colour both sides

Diyisfun My plan was if I received any thing from the leaflets then leave them with a business card,