Search results

I agree a good handsaw [and a good man]will cut a 40 mm worktop faster than a jigsaw anyday

I did say that the flow rate and the pressure is very good.also the property is a new build next door to my present home which has had a Combi for the last 18 years,

Not actually measured it, but both seem to be excellent [High]

I have just ordered a Boulter Buderus Combi, looking at their website it says mains water in fitting, on jig is 22mm , plumbing 1st fix has been done and mains water to boiler is 15mm, Do I need to go back to stop tap and change to 22mm??

This is a self build, I used to be in the building trade I am not too far away from you [Thirsk]

Thanks Paul I can buy a 500 warmstart inc flue, VAT and delivery but excluding modureg for £700 is this a good price??

What is the difference between the 500 and a 600 boulter buderus combis,and are they both warm start??

I am self building a new bungalow, all the pipework is in for a combi in the roof space. I am now getting nervous re combi, question is, is it still practical to change my mind and put in system boiler and a cylinder, I do not think funds will run to a pressurised system, other query is I have...

Thanks for the info!!

Do not know if this is the correct forum but, anyone know the minimum height kitchen wall units need to be above a gas hob???

Just cut out of the corners with a jigsaw, then use a good old fashioned handsaw to join up these cuts.

It would appear that the second one did not cure the problem, it just improved it,after having no hot water at all, anything is an improvement ,as I said even after the second replacement the flow pipe was still getting hot, when I beleive the heated water should be "diverted" away from this...

Some of you will remember my Worcester 9.24 combi ,hot water only working with CH, so changed diverter valve, this made no difference, so removed secondry Heat exchanger and cleaned/descaled. no difference. so fitted another new divertor valve, hot water now OK with or without CH but flow pipe...

Sorry yes I suppose it would be expensive just for one hole, If you were anywhere near me [Yorkshire ]you could borrow mine, ask around friends. good luck.

With a one inch drill

Thanks for the prompt reply I may be OK then, I think it is 400mm away from the tap [it is behind and above the basin]

I am currently doing a self build, Elecrician has done 1st fix, but I in my wisdom have moved the washbasin in the bathroom, this may or may not mean I also have to move the shaver socket, can someone please give me a distance it needs to be away, or point me to a Zone diagram if that is what...

Update New diverter vale was faulty, fitted another new one , now have hot water again flow pipe still gets hot though. Thanks for all the help

much appreciated ollski Thanks

I have fitted a new diverter valve and the problem was the same with the old one. On the old valve the only problem I could see was that the plastic ring in the end [outlet for flow pipe] that is retained by an internal circlip, was broken. Any ideas where I might see an exploded diagram of...