Search results

Put one of the sounders in SAB Mode and the other one in SCB mode. SCB mode draws the power from the internal battery only. It says how to do this properly in the manual of the sounder. But... I think it is one of the jumper links on the PCB, near the battery enable jumper. Hope this helps.

Checked the Battery Fuse? Just a thought

Just a quick question, my internet connection speed is naff, and after reading this forum, i think the problem could be with the ring wire. Had a nosey in the Bt master socket, and i have an extension connected to most of the terminals. Could i just basically disconnect the ring wire? Would i...

If it still works, then leave it alone. Do a bell and walk test as described in the user manual, to be on the safe side. It should highlight any obvious problems. Seems weired that it has changed on its own, but hey ho, it still works!

Go check, and post back! They can be programmed to do this, its an engineering function, so unless you have the engineering code, you can't change it, unless you default it. Just a note, its not flashing is it? That indicates a power fault with either battery or mains. You did say...

EOL means it uses resistors. You have 2 for power. You then have either 2 for alarm and 2 for tamper, or 2 for both tamper and alarm. What alarm panel do you have? There's more info in the sticky if required

I have an MDT Avanti alarm with prox RKP. Inside my house is a soundbomb and every so often, it gives of like 3 clicks and a very low frequency buzz for about 5 mins, then stops, Why is it clicking and buzzing? Also, how warm should the endstation get, i've got 3 pir's 1 viper and a door...

Wonder if any of you chaps could offer some advice.... My internet connection speed is shocking, a measly 325 ish kbps! The broadband is tiscali, who have apparantly merged with talk talk, and this speed is constant throughout the day, with the odd fluctuation of around 10kbps. When you...

Recieved the Item the other day, and it WORKED. It looks a lot better than the Mk3 keypad. Although,l have to say, when entering my code and pressing A/B for the required set, instead of beeping twice when set, it gives one beep, but slightly longer. I am unsure about this, however its sets and...

I know, came with house but smashed keypad off the wall when moving wardrobes! I'll try it and see and report back!

It says version V1.04, i guess not then. The guy on ebay said any galaxy panel though?

Would it be possible to swap a Mk3 keypad to an Mk7 keypad on the above panel?

That should be Ok as there are usually knock-outs at the back of the panel. Power in parallel and alarm and tamper loops in series, back at the panel end. That would be the easiest way if you can't get a cable to the living room

Ive had that solo"no climb" stuff before, works a treat! However, because its a Cafe Bar, we open on a night, and before the smoking legistlation came in, people were able to smoke in the building, which the company said it was not a problem, and fitted rate of rise detectors, some of which...

That looks like alarm cable from the fuse box, Its very thin, Surely not?

I have a Cafe bar with a properly installed fire Alarm, serviced anually and i carry out all the required tests, call points, detectors, sounders etc. It isn't monitored. Some of the detectors are in silly places eg. A smoke detector outside a kitchen door! Anyway, i just find it odd that in...

So how do you get the e/e tones louder than the keypad buzzer?

Just recieved a galaxy 8 alarm and mk3 pad. Just a few questions before installing. Looking at the manual: How do you wire a speaker to the system? It doesn't seen to explain it clearly in the manual thanks

Hi all, i recently installed a veritas 8c alarm. Recently, the alarm has been randomly going off, 24hr led, Zones 4,5,1 have all been randomly going off when unset. Checked the programming and all looks ok along with the cable runs and connections at the panel. Is it time to replace the...

Think it is time to bring in the engineers and it would be easier for me and the work would probably be guaranteed. I could also get a new panel fitted at the same time