Search results

On the 9800, A is the full set, B and C are the part sets. The LED's will illuminate when that current part set is armed. With regard to the zoning, a contact should be placed on the front door, as this can end any excess exit time, and arm the system. If you have to pass any detectors, they...

I know this doesn't cover it all, but its much better than the yale, and fairly easy to install: http://www.e-fireandsecurity.co.uk/visonic-powermax-new-version-wireless-intruder-alarm-kit-2/p10...

Its to do with when your having more than one viper on the same zone. It requires at least 7 cores. Two for power, alarm cct, and tamper cct, then you have a switch wire. Say there are 4 vipers on one particular zone, the first viper that activated will flash, subsequent vipers will be...

Your panel is asking for a remote reset. By default these panels are on engineer reset on end station tamper, but the installer has obviously selected the remote reset on tamper as well. You'll need to contact the original installer, as you might still have a service contract or monitoring...

I think you have to program old veritas sounds, used with older keypads. Its under one of the misc selections menu's.

The RKP's backlights are on all the time. So quite simply, no.

Normally, a bell tamper consists of a 0V feed, goes through the switches and comes back and connects to the return terminal of the control panel. What bell box have you got and what control panel?

http://www.riscogroup.co.uk/Products.aspx?subcatid=165&id=20

AFAIK, the external sounder cannot be changed when a fire zone is triggered. You probably pulled one of the wires out for the bell trigger. Try doing a bell test, and see if it works.

Yes it does Yes, but it can be silenced if you have the correct code. try it and see. Thats the engineers code. 0123 is the default user code. You did say that the day light was off. This would indicate that the system is set. If i was you i would get an engineer in who would be able to...

What system is it? you may have blown a fuse when moving the pir.

Spider wouldn't have set a tamper alarm off. Have you actually tried resetting the system? enter your code to reset or if you haven't got a code try 1234. It might get rid of the tamper light. To change the battery, open panel, enter code to silence, remove old battery and replace with...

You definitely need a new battery if it hasn't been used in 13 years, they only last about 5!! this one would do fine: http://www.e-fireandsecurity.co.uk/2-4ah-12v-alarm-battery-rechargeable-sealed-lead-acid-battery/p260 With regard to the tamper, have you had any new carpets recently...

According to the manual: "Entry Time This is the time allowed to enter the premises via the entry route and unset the system. The programmable range is 00-99 seconds. The actual time is multiplied by 10 00 = 5 seconds 01 = 10 seconds 03 = 30 seconds 99 = 990 seconds (16.5 minutes)

You need a new battery. A 2.1Ah one. http://www.e-fireandsecurity.co.uk/2-4ah-12v-alarm-battery-rechargeable-sealed-lead-acid-battery/p260#tdesc_1

tbh, i don't think any 9448's have the option for an engineer reset on tamper.

Don't you have to press SET to save the changes you've made in the menu? Just a thought.

Will do, thanks for the advice!

That is correct, no connection to ARC. Does turning off EN50131 do anything else, other than enabling the LED's. Thanks

Anybody know how to get a premier 24 to display its status permanently i.e the ready and info led's, rather than hide them until a code or prox tag is put in/swiped? Thanks