I Can't set timed entry mode for p1
I have the G4 and my front door sensor is on zone 1 and a hall PIR on zone 2.
The operation I want (for p1) is that once the door is opened, I should have time to get to the keypad to disable the alarm.
I have been able to do this for p3 but not for p1. My intention for p1 is for all zones to be enabled (p3 has upstairs disabled)
For p1, I have set the front door as timed and the hall PIR as inhibit. When I enable the alarm, it complains about the front door being open (which it is - waiting for me to dash out), once front door is closed the alarm enables and all is fine. However, once I open the front door again, the alarm goes off immediately - panel shows front door as being the activated zone.
The exit mode is set to final door and both entry & exit timers are set to 03
Any ideas how to configure the alarm (n full set mode) so it allows time to disable it?
I have the G4 and my front door sensor is on zone 1 and a hall PIR on zone 2.
The operation I want (for p1) is that once the door is opened, I should have time to get to the keypad to disable the alarm.
I have been able to do this for p3 but not for p1. My intention for p1 is for all zones to be enabled (p3 has upstairs disabled)
For p1, I have set the front door as timed and the hall PIR as inhibit. When I enable the alarm, it complains about the front door being open (which it is - waiting for me to dash out), once front door is closed the alarm enables and all is fine. However, once I open the front door again, the alarm goes off immediately - panel shows front door as being the activated zone.
The exit mode is set to final door and both entry & exit timers are set to 03
Any ideas how to configure the alarm (n full set mode) so it allows time to disable it?