Search results

how do you mean running out the tank ? is the over flow running out side ? is the ball valve still filling up ?

^^^^^^ like the man said ^^^^^^^ if your still getting problems after you have bled it, turn the hot water on and give it few mins then turn it off again and re bleed it theres prob a fair bit off air in the system with the cylinder being in the loft

hi mate it sounds like you have a air lock on the cylinder coils, is there a vent on the pipe leading to the flow of coil? if so you will need to open it and bleed the air out

lol alarm love see em kick that in unfourtunitly am having to take out my beautiful brick shed to make way for her raised decking area :cry: fooking women :roll:

ive seen that Shiplap here http://www.savoytimber.com/timber-sheet-materials/timber/pine-skirtings-etc-/shiplap-cladding-redwood-/prod_592.html but dont no if its a bit thin as am wanting to dubble it up as the fence?

no not lived in, am re doing the garden and using the back of the shed as part of the fence saves on fence pannels and posts, i was thinking of 25mm decking boards so the kids cant kick it in from outside but cant think of away to make the joints water tight ?

would treated floor boared be ok to make a shed from ? am only asking because its the only type of t&g wood i can get from the supplyers?

just been looking round for a new shed to replace my smaller brick shed and the prices are stupid for the sizes ! as am remodeling the garden ive decided to build a shed and use the back wall of it as part of the fence. i was thinking of 25mm thick decking boards but ive no way of making the...

did they do a power flush or just put the fernox in the system ?

ok point taken didnt reilise it was so many turns per second works on the biasi magnetic switch tho

so what your saying is that a magnetic filed is picked up by the clip on switch ? humm i musnt know what am on about then ay ? may not be able to spell while seeing to my kids but am sure the switch will pick up a magnet moving over it thanks

wil be a magnetic read wetich use a small magnet to see if the switch isworking

balanced the system out using the lock sheild valves go to the 1st rad closest to the boiler and shut the lsv ( lock shield valve) then open it half a turn then go to the 2nd rad shut it then open it 1/2 a turn and a bit an so on by shutting the valves down it will force the water to take a...

i don't think the ability to spell a boilers name has any bearing on there ability to do a good job or give good advice !

does this mean like a green furry substance on it ? if this is the case then it will be flux residue use a bit of wire wool on it and it will be fine. if its like a yellow crusty lime deposit its been leaking at sum point and sealed its self may need replacing dont clean it as it could start...

is the clip a micro switch? or just a piece of blank plastic ? if its a switch push it in wen hot water is running if its a a blank piece of plastic its a magnetic reed switch so use a magnet over the it an see if the boiler starts up again make sure water is running you don't want to kettle the...

just buy a full new head for it i don't mess around changing the motors

worchests used to be really good boilers but ive personally found they have they are no wear near as good as they used to be so i would stay away from these, vismen boilers are mint but parts are expensive for them so id suggest the valiant for middle of the road am sure someone else will...

with out checking it, it sounds like a water flow switch. These boilers dont have a divertor valve it works like a multipoint it heats the water up directly tho the heat exchanger not indirectly of the central heating water. so as long as the central heating is on you will get hot water untill...

the wireless room stat / timer runs on radio controlled frequency the receiver picks this up and flicks a relay to 240v and makes the room stat connection in the boiler. am sure some were like maplin will sell some think like that. only other thing i can think off is finding out the frequency...