Search results

Looking for a new washing machine which must not exceed 595mm wide. Ideally 1400 - 1600 spin, with a 6kg drum. I understand the best makes (excluding Miele due to the higher cost), are Bosch and Zanussi, but their machines are all 600mm. Can anyone recommend anything? I don't mind paying...

No obvious breaks in the seal. As said before only thing I have noticed is the seal at the bottom of the door curves over at the end. Spray arms look to be OK. Don't use rinse aid. Only the 3 in 1 tablet. Should I get suds at all? When opened the machine mid-wash the water level was...

I do recall noticing before that it was folded over at one end.

Using Fairy 3 in 1. Always have. Only suds come out the door (cycle in progress as I type). Will check door seal once finished. What should I be looking for?

Had this dishwasher for 2 years (came with the house when we bought it). Have had no problems except until now when suds are coming out the door at each end. Seems to drain OK. No error codes. Is this a door seal problem?

I have planning permission for a first-floor side extension (bedroom on top of existing garage). It came with the house when I bought it and runs out mid-September. I am advised that if I start work before the deadline, then I will not need to re-apply and can continue at my own pace...

Insert disc into player, and comes up "no disc". When I listen carefully, I cannot hear the disc spinning. Help please?

Thanks rocks1, will look into this. But how easy is it for a novice like me to change this? Do I need any special gadgets / know-how?

Just thought I'd post an update to this. Rang engineers (yes I had to chase them!) - once they realised that the model was over 7 years old (and not 4 like they originally thought), they confirmed that the board CANNOT be reset - and I would have to buy a replacement board. So it looks like...

Have already done this myself - switch clicks and no blockage.

Is it feasible that once the blockage has been cleared, that the PCB needs to be reset? thinking that without doing this the PCB will still think there is a fault and continue to overfill. If so , how do I reset the PCB? Engineer is waiting for Indesit to call back and I want to speed...

I think he's hinting at just buying a new machine. From all the research I've done it seems to me to be a simple problem. I'm inclined to open it up again myself and double check the pipe/switch. Am i right in thinking that I can test the switch by detaching the other end (attached to the...

Called out a local engineer in the end as thought it was easier. He checked out the pressure system and was fairly adamant all was OK. Therefore, put it down to either a "valve" or possibly the circuit board. He has gone away to check out the error code (even though I told him 3 times what...

Have blown down the pressure pipe and doesnt appear to be a blockage. Machine still overfills. Switch problem???

Still none the wise but will try tomorrow!

OK - but how do I go about fixing this? I am a total novice with this kind of thing!

When running a wash programme, I have noted that the drum fills to about 3/4 volume with water. The display then shows an -H20 error. When I phoned Indesit, they could not explain what the problem was as -H20 normally means the machine isnt filling! The wash cycle then contines as normal...

Disagree with this. If the retailer tries to repair and makes it worse, for example, then you are still entitled to a replacement/refund. Had this before with a sofa; one is legally entitled to reject a repair even after it has been carried out. Still, this does not answer my question...

Recently purchased an ash table from a local retailer. When it arrived, I noted that there was glue on the wood; this seems to have occurred when the manufacturers stuck in the granite centrepiece and the glue obviously hadnt dried before moving it. There is thus a small film of dried glue...

What problems? I have been told elsewhere that power flushing would not necessarily cause a problem.