Search results

this place ( ihave used) are really good, they do a no frills range at the bottom, without grills.....much cheaper than sf.. http://www.compass-plumbing.co.uk/RadsonSupaPriceList.htm also Wickes have 33% till march....i got a double with d/c 620x1000mm for £50 all in.....better than...

yes but I have said the place where it is is like a cold spot.... a bit of a sh*t......anyone use danfoss tp5? would you mesure temp in a room and decide where to site it.... Darren?

yes the air was really bad upstairs, and is a little better now....the towel rail was the worst......but the caps on the top are a good place to put the senital x100..... so its tvr and wasps open then bleed and balance....thanks guys Darren

I have had all the rads off as the plasterer has been in? the system is fine, I upgraded one of the rads while they were off to a double....that is is.......I have asked position of valves, and then you ask me what I have asked! I have even told you the makes. D

Hello, My thermostat for my combi is in the corner of the room at the bottom of the stairwell. It is fitted at the (danfoss tp5) correct hight and distance from the corner of the wall, but it is in a bit of a cold spot. the downsatirs is open plan and has 3 rads. I was thinking of moving...

ok this has been asked many times, I know.......... just cant seem to get the air out the system....... downstairs 4 Radiators, 3 have TVR and Pegler Wasp on the other end, and 1 (porch) has wasp both ends. Upstairs 3 rads and one heated towel rail, all rads have TVR and wasp on...

wellsome have said that it should not really rise that much, sometimes to around 2.3 and as I said it is at 1 cold....well as I had the whole thing drained and all the rads off, I would just like to know the correct way to pre- charge the vessel..... as most have said if it was not checked or...

anyone please :(

sorry ment Financial reasons.. Its just I did see a post from meldrew's_mate sayiing this well the PRV had a cap on it, und feeling underneath it looks as if it turns. can or has anyone done this, and how do open the PRV on this model, fully counter clockwise? then clockwise to snap it...

Hello, I have an ideal isar boiler, it is around a year old but has been only used for around 5 hours, as I have not been living the house, due to fanatical reasons. The system was installed a heating engineer who was local to me but has now moved abroad. I have just had the house...

Many thanks Darren

I have a 500w PIR and was wondering what the correct circuit to put it on. I have had some people say it can spur from an RCD protected circuit, and others have said it must not. what is ok please Darren

As I was saying in my post, the latest Wylex 100amp split load cu only state a maximum of 16mm for the tail size, as this is restricted by the terminals. Maybe people just put a crimp on the end, to fit 25mm if someone can respond. Darren

Thank you Pdcelec. So when people fit 25mm, they put terminals on the end of the tails, as there is quite a few ( new builds) running this. Darren

Thank you, Looking at the latest wylex split load cu, it says maximum size for fittings 16mm, it has a 100amp trip in this unit, What I am saying is how do people get 25mm in units that take 16mm. Many thanks Darren

Hello I have been looking at my CU. Well I looked and saw that the earth looked very small (TN-S) well it looks all ok at the service point where it comes in the the house, but then it is about half the size, where they have changed the CU in the past and moved it, they have joined it with like...

yes there is some on there but not fitted views, just bare ones! I have seen some shots on here before but cant find them. Darren

switch does not matter if it is 45 or 95! it is the breaker that it is connected to( and the cable ) 3kw is not a lot. some have plugs on.

I do no the regs and have not asked advise on them. part P is posted many times. I would just like to see some split load shots, sorry for that! Darren

My Brother has a Wylex 12 ways spit load, well it really does look a little messy.( It was there when he moved in) They have left quite a bit of length on the cables so that will give me room to tidy things. They have also fitted an isolator, so this is good. I like the look of the...