Search results

Hi there, The shower hose itself hasn't collapsed has it, try another / new only be a couple of quid Rico

Hi there, THink they are designed to go into compression fittings. It goes between the trap and the waste. The trap should have a compression fitting on it already and then just get yourself a compression straight connector. Like these Rico

Alternatively, you could have donned a wetsuit or stripped down to your skivvies, got in the tank and bunged it, done that before now. Rico 8)

IMHO, It does'nt matter what he did to breach the conditions of his licence, He should now be held in jail for the remainder of life & his right to anonimity removed so all the cons inside know who he is. Rico

Blas, FFS stop reading the mail, they're infecting you with their Paranoid Rantings & drivel Rico :D

they are waiting for him outside our house, he passes a breath test Think again dex, wasn't drink driving :roll:

HI there, BY some Grot Buster, its a thick bleach. http://www.wilkinsonplus.com/invt/0265163 Will clean it up luvvly jubbly Rico

If the invite came to you, bin it, burn it. Usually these things are just a scam to get a joining fee off you. Promise of work then nothing. Rico

Like I said really down to customer preferrence as to how far they want the rad sticking out into the room. May also depend on what they have covering any windows, if short curtains, then use the big side, so the rad is out past the curtains and less heat is lost up the back. Rico

Hi there, Its ok to do all the pipwork in 22mm as that is what you have already, this size is normally used on gravity systems to increase the flow rate. On mains systems, 15mm is used as you don't need any additonal "help" to increase the flow, and on mains systems using 22mm does'nt make...

only really for aesthetic reasons, whichever you prefer. Rico

Hi there, If everything is mains pressure, which it sounds like it is, yes no rpoblem with the extended run of 22mm, alothoug would be better if everything was run in 15mm. I can never understand why people mount these mixers on the wall side of the bath, unless you have easy access from...

Hi there, It may have got the old water out. Depend where on the loop the drops are, the water will always that the path of leat resistance, so may well have bypassed the other downstairs rads. Only 1 way to find out, get the 5 rads off the wall and check. Rico

Hi there, Your never going to get all the rads empty from a downstairs drain off. You have to individually empty each downstairs rad, the water cannot flow back up. Rico

Stuart Tuner are mutts nuts. -ve head used for showers with very little head pressure or where the shower is above the cwsc. Rico

Hi there, You can make up your own t-bar. Long piece of 2by1, cut V notch in the end, nail another pce across the top and you away. A part from that stopcock leys are only about a fiver. Rico

Well your orignal post did'nt really make a lot of sense did it. Try re-wording it, tell us exactly what you're after.

Full Bore Lever Valves all the way.