Search results

Hi £160 a ton.

Hi. What make is the 2 port valve.

Hi. Water pressure low maybe?

Hi Has the system been properly balanced. An explanation of balancing can be found in the FAQ. HTH

Hi The noise probably is from a ball valve inside the toilet cistern or in the tank in the loft. HTH

Hi My opinion would be a blockage around the tank h/w outlet or the pipe off of it. Likely caused by limescale. I would also check the level of water in the header tank and that the ball valve can keep up with the h/w output. HTH

Hi Might be a partial blockage in the pipework. When you had the rad off did you check the rad valves pass water? HTH

Hi The tap is just stuck on the splines. Pour hot water over it that might free it. The tap might break with to much force.

Hi My monies on a buildup of limescale round the neck of the cylinder outlet.

Hi Could it be these http://www.westradiators.co.uk/radiator-valves/thermostatic-radiator-valves.html

Hi You have answered your own problem. A piece of pipe level with the out side face and a pan connector should do the trick.

Hi Take the cistern out tighten the nut hand tight, then quarter with pump pliers and leave over sink to check for leaks for a while. No sealants should need to be used. And always leave provision to get at it and fix it in the future. With all toilets you will have to sooner or later.

Actually too high if I remember right.

Hi Water pressure too high or low. Should be 1-1.5 bar. HTH

Hi My choice would be stored as they are easy to install. And under 15L require no g3 ticket to fit. For 10k water heater you'll need a 45A wire. This will need a dedicated position on the fuse board. HTH

Hi From what you say in your second post I'd be inclined to look in the neck of the tank for limescale buildup. HTH

Hi Replacing individual parts on older taps can be more expensive in some instances than buying altogether new. With the added disadvantage it might not work. HTH

Sorry. Should have asked what make is the working parts?

Hi What make of toilet?

Hi You can add ptfe tape to the olive. If when you take it to pieces and you find you can move the olive easily I would say it was not tight enough. A few other things. Make sure the pipe is clean, the pipe end is square, straight and inserts to the stop colar. Good luck