Search results

Have you tried simply resetting it? Usually done by locating the button, pressing & holding :)

Figured out its a shaded pole motor, just need to know if it has 2 separate windings & why 1 appears open circuit.

I'm trying to figure out if a motor like this one Is kaput or not, it has 4 wires, 2 are neutrals that are tied together in a choc block & 2 are I'm assuming live inputs that go into the timer control board. I've done a few tests & 1 live input has about 10ohms to neutral but the other...

Is there Auto detect in you're BIOS? If so try hitting that!

Hey don't mention it :) If the oil came out quite black then my assumption would be there are clutches at work inside indicating an LSD, the oil you have used will prob not affect it tho :D

Thanks GG!

This does seem to be a grey area! I've just had a look around & no one on the internet can give a conclusive answer either :( Short of stripping the diff to find out my only suggestion is to see if the existing oil in the diff has any unique features such as colour?? Have you given the...

How much would it cost too connect a gas oven (rough idea please) to an existing capped off supply pipe. I know it can be abit crystal ballish with these things but I'm just after a rough idea of what gas engineers charge for this please :) Paul.

Is that a pic of the underside of you're Jetta's radiator? The part looks like the coolant drain tap normally found at the bottom left hand (near side) of the radiator, try tightening it maybe.

You should be ashamed of those pictures they are awful! IMO its a jack block from one of the corners of the sill :)

Injectors are coded due to the fine tollerances they are made to & the necessity of modern diesel engines to be injected with precise fuel quantities, each injector is slightly different so the code on a new injector has to be programmed to the ECU so the ECU can compensate for the amount of...

Is the noise happening when the steering wheel is turned & the vehicle is stationary?? Thats how the OP`s post reads, if thats the case it sounds like the EPS motor on the column is worn. If it was CV then noise would happen as the steering was turned & the vehicle moved.

Looks like the aircon water drain pipe, might live on the side of the transmission tunnel.

You`re dashboard has gone blank!? That`s alittle more urgent than a radio code, you need a new dashboard unfortunately :(

Rear hub bolt factory torque is stupid!! 180Nm + 180deg!!!!! Last time I did one (on a MK5 Golf) I managed 180Nm + 90 deg before I decided something was going to snap :D

All you will have to do is set the clock & program the windows for Auto up/down, to do the windows simply hold the switch to the up position for a few seconds & test it, repeat for the other 3.

Can also be used as a Tazer! :lol:

If its saying `Phone` on the display then its highly likely the Phone mute wire is grounding out which is often left dangling un-insulated behind the radio, when a negative/ground feed is applied to this wire (usually a yellow wire) then it mutes the radio. Remove you`re radio and locate and...