Search results

I need to change the mixer top washer. There is no name on the tap and no screws to take it apart? Any help will be most appreciated. See attached

I contacted Jackery Power Stations:- "The Jackery Explorer 2000 Plus can work with a thermostatic fan heater. However, you need to ensure that the heater's power requirements do not exceed the power station's capabilities. The Jackery Explorer 2000 Plus has a maximum AC output of 3000W and a...

I have a VTOMAN portable storage Battery - "VTOMAN FlashSpeed 1500 Portable Power" I tried to run a 700w thermostatic fan heater. It was fine until it reach the required Temperature, and when the fan click off, the Battery turned off. It won't turn on again until you switch it on. I tried...

I should have said that I fitted a new head.:unsure: I need a new head for myself.

Warm greetings friends. The TRV4 Rad Valve is not responding to the valve and stays hot. The valve pin is working -pressing down and springing up. Any advice will be most appreciated.

Thank you, my friends!

Because of the drop, the 2 doors won't open properly and scrape on the flags. The summer house is 8 sided. It is dropping on both sides front end. On the cat flap side it has dropped, cracking/breaking the floor board. 3028/3029/3033 On the opposite side fig 3019 & 3025, it has rotted and dropped.

Yes!! Thank you!

I'll take some tomorrow. I live in North Manchester but could not get anyone to look at the job.

I'll take some photos tomorrow. There is a double door at the front which does not meet anymore, and leaves a gap as mentioned above.

Warm greetings. My summer house has rotted/separated where the wooden side meets the wooden floor. The floor is supported under neath so the wooden side has slid down a bit. The result of this is that the wooden double doors have parted by approx' 1.1/2" at the bottom and about 3/4" at the top...

Thank you.

about 15ft

8ft lengths are probably the longest I could get down the trapdoor. Could I glue and screw two lengths butted together, then another piece overlapping the joint?

With sistering does it have to be the total length of the joist, or can you do the middle part only?

I was looking at some YouTubes about curing 'bouncy' floors. Some joiners were fitting wooden 1 x 3 'strapping'. These were screwed across the joists covering the whole room, 12" apart. Is this a good method??

Great idea!! Thank you.

I am fitting some noggins in floor joists. The gap seems to vary slightly as you go. If I cut a noggin that is slightly smaller than the gap, is there some way to wedge it, or do I have to cut another? I thought you could measure once and cut a dozen noggins but....:cry::cry::cry: is there a...

Twas the cistern! I have cushioned it from the tiles, with rubber washers. Let us hope it does not come back!!‍ Thanks to everyone for your input!