Search results

  1. C

    If fitting a drinking water fountain is a double check valve required?

    Thanks its and upward facing jet, so will fit a double check valve. Also does anyone know what kind of height to set at. Would the normal basin height 820mm be about right?
  2. C

    So they sell speed fit or polyplumb in 10 meter coils

    As the title don't really need 25meters
  3. C

    If fitting a drinking water fountain is a double check valve required?

    Thanks not seen it yet off to look tomorrow. Agile your description of when one may and may not need one makes sense.
  4. C

    If fitting a drinking water fountain is a double check valve required?

    If installing a drinking fountain is a double check valve require on the cold feed to it?
  5. C

    toilet flush valve backnut how tight?

    Hand tight and half a turn?
  6. C

    toilet flush valve backnut how tight?

    How tight does the back but on a toilet flush valve need to? As its plastic too tight and it will break.
  7. C

    Flux on stainless steel sink

    I spilt abit of flux on a stainless steel sink which has left a mark any ideas on how to remove it? Or has it corroded it?
  8. C

    screwing boiler stand off bracket to wall

    Stand off bracket so pipework can be run up behind the boiler
  9. C

    screwing boiler stand off bracket to wall

    The firms gas safe engineer
  10. C

    screwing boiler stand off bracket to wall

    Think I just over think things I as I have fitted brackets for boilers before and usually use more than the 2 screws the instructions say
  11. C

    screwing boiler stand off bracket to wall

    The screws that come with the boiler are usually un-suitable for dot and daub walls are there not long enough.
  12. C

    screwing boiler stand off bracket to wall

    Just because the instructions say one either side of the bracket even though there are hole for more? Would think more screws would give a better fixing?
  13. C

    screwing boiler stand off bracket to wall

    Did people tend to use more than 2 screws recommend to screw a boiler bracket to the wall?
  14. C

    draining heating to repair pipe with naill in

    Not trolling just after as much info as possible
  15. C

    draining heating to repair pipe with naill in

    Are the more expensive inhibitors worth the extra money?
  16. C

    draining heating to repair pipe with naill in

    I just wondered sorry. The section of pipe work is on a drop with no drain off on so will drain through the rad on that drop.
  17. C

    draining heating to repair pipe with naill in

    Thanks so no probs with system being empty for a day or two. Its mains
  18. C

    draining heating to repair pipe with naill in

    Is it ok if the new inhibitor mixes with any left over inhibitor in the system.? Though dont know if any was in originally. Also is it ok to start draining down. Then go back the next night to repair. The heating and hot water arent working at the momment as no ones living in the house
  19. C

    draining heating to repair pipe with naill in

    Thanks then put a new bottle of inhibitor in?
  20. C

    draining heating to repair pipe with naill in

    But they dont do compression slip sockets? The pipes in a stud wall so wont be assesable at all after. Its my friend s house just helping him out. Was going to put two slip sockets and a small bit of pipe in
Back
Top