Search results

I am having the bathroom rehashed and was planning on putting a 2.5-3.0 Bar pump in for the shower, the bathroom shop has suggested a "pressurised Vented Cylinder" Could someone tell me please? Where would be a good place to buy such a cylinder How much should it cost to install Is it a...

Hoping someone out there can help. Having a new bathroom fitted visited every bathroom shop in the area eventually found a suite that me and the missus agreed on then found the importer had gone bust. We were trying to buy a "Yukka Trio" suite with the importer being "Plumbing Imports" in...

Ok thanks for the reply's. looks like an unvented system is out of the question however, what about a vented thermal store? Would it be a big problem if the feed was only 15mm?

Thanks for the reply. just from what you have said it already sounds like a longwinded, expensive route to take.

How difficult is it to change from a vented system to an unvented system. Also what are the costs involved. I an having a bathroom refurbed and someone suggested changing the gravity fed system that I have to an unvented one, as a second option instead of installing a pump with a mixer shower...

Hi, Could someone tell me how to remove the side panels from my miele washing machine (Premier 500) please? The machine does not complete the cycle and says "Check Drain" I have tried to get the side panel off, but it looks like you have to remove the front to get at the last 2 screws. Thee...

Someone wrote in a previous thread," "the 3 way valve was not sealing when the h/w circuit was meant to be off " How would you check for this? I have a noisy CH system as posted in an earlier thread, I have since balanced the radiators, but we still have the noise. Is it possible that I...

HI, How did you find out that the valve was not seating? This could be what my problem is.

Sounds the same as the problem that I am having. Posted in another thread, the reply's have suggested that I balance the rads. Maybe you could try the same.

Chess: The valve seems to have some sort of extended stem on it. I have been told before that the bathroom radiator was used as the bypass or heat sink for the system and wondered if this was some sort of locking mechanism. Nige F: The 3 way was not an identical replacement and iniially I...

Thanks for the reply. I have read quite a lot on this forum about balancing the system, so I shall give it a try first. I have noticed that the lockshield on the bathroom rad does not seem to be adjustable, it looks a bit different to the others. As if it has another bit added to the top.

Bump :( . Any ideas or suggestions please

Hi, I live in a house with a very old CH system and boiler. The system seems to have 22mm pipes with 10mm pipes tee'd off to the radiators, therefore as I understand not a proper microbore system and also not quite conventional ie 15mm to the rads. During the winter we put the CH on constant and...