Search results

Thanks for the reply! It’s the texecom connect, I’ve come across another issue in that it keeps disconnecting from the WIFI. If I disconnect com1 when I plug in for Wintex and then when I’m done plug back in it connects fine and the WiFi icon goes solid. Then after a while it disconnects. I’ve...

Today is a good day :) I started from scratch with everything and managed to get it all working, even wintex and the smart com! Couple of outstanding issues: 1. The texecom app likes to crash a lot 2. When I arm the system it says "Area in Exit > A" and the panel sounds and does not go off. I...

I’m out at the minute however the WiFi light did change speed of flashing which indicated it had connected. I also got the confirmation on the browser that it had connected.

I followed this and it got stuck at the enable texecom app. It just says call retrying no carrier

I tried again from the start this morning and it gets stuck when enabling the texecom app

If I go back to the start, I move the jumper back to commissioning and set everything up the move back again? I’ve read somewhere about leaving it for 15 mins

I’m miles away from the router unfortunately

I think I might start everything from scratch again and reset the panel back to default. Apologies in advance as I’m a complete novice, what are the steps to set up? Ie put back to commissioning mode, learn devices, set up areas? Set up zones? will I need to take the bell box down? Etc etc

Makes sense (y)

Thanks for the reply. Yes to all the above, With the SmartCom, I followed the instructions online and everything went perfect until the part where it generates an app code.

Oh and the PIRs don’t seem to be lighting up after I put the covers on. :cautious:

It’s my first post so go easy! I’d like to think I’m quite good with electrics and computers however the texecom ricochet has completely ruined me! Got all the kit this morning including the connect so I can use the texecom app. After a few hours of drilling and plugging etc then reading...