Search results

GET PLAIN SOFFIT WITH OVER FASCIA VENTS :)

these types of mechanism are prone to corroding where the rods come through the carriers on the end and they often seize solid you don't need to take glass out unscrew end angled carriers and handle and any other retaining screws and the lot should come out now you can check whether it is...

probably double glazed with laminated glass super spacer and argon filled I think :-)

as already stated should have thin bead of silicone around cassette also must be sealed around letterbox as they can leak through. no silicone within cassette, usually held in with double sided tape

perhaps the opening sashes have bowed slightly remove beads and pack out frame outwards check tightness of seal by opening window and trapping a piece of paper between seal and frame, close window and see if it grabs the paper

and for gods sake ask them to use rosewood silicone !

in answer to your question, yes its a rush job! I can only go on my own fitting and I would have expected 2.5-3 days to do this on my own, sealed up/foamed outside then cemented over to match then neat bead of caulk round inside against reveal. I am guessing they have made them smaller so that...

I have done a few of these I screw 3" cls to underside of rafters then fit kingspan type insulation 50mm between the spars this gives an air gap between polycarb still then upvc hollow soffit over the top . materials are usually around £300 area and it does make a lot of difference the only...

angle iron will do it acro it up and slate it

normally builder would put wall plate on then joiner fits roof timbers, trims all rafter ends and fits fascias soffits and guttering and frames out for velux windows then roofers would come and felt batten and tile and do all relevant lead work if you have a good roofer then he will be able to...

your old units may have been laminated glass units which are better at sound prevention and the new ones, whilst being a rated, and better at heat retention, would be noisier than your old ones just a thought ??

that's the one just need to find somewhere near you now :)

you may have to ring them up there is nothing in their brochure, ask for 3mm window board or reveal liner I know my branch stock it

try your local branch of eurocell or roplas for over boards they stock a 3mm fascia board which is thin enough to fit on top of the existing cill and underneath the front edge of the frame thus not interfering with drainage channels ive used them in past and do work and not expensive

should be done with super spacer bar really not aluminium easier to work and better u values

I would have thought so :)

when the doors are shut together is there a upvc section in the middle that is attached to the door on the left this whole section(mullion) should be able to be unscrewed you should be able to see unless it has been screwed behind the metal locking plate

if its the slave door in a set of French doors then you have to take the mullion off which is the vertical bar which is screwed to the slave door you should see some screws holding it on then cylinder access will be underneath

about £350 without seeing it !

the rehau system with 3 chambers is a bit out dated now you really want to be going with 5 chambers with warm edge spacer and argon filled units with either planitherm or KOW to get an a-rated window you will struggle to get a b rated with rehau 3 chamber . 5 chamber windows are more...