Search results

Thanks a lot of my rads have the auto vent fitted , do I need to do anything or shall I just call the engineer back. Cheers

Hi All Just had Vaillant ecotec 615 serviced today and a new prv. Just noticed boiler had a F23 temp alarm and said to turn off the boiler. ive turned it off and back on and it's gone away just now, apart from ringing the engineer tomorrow . whats the problem and can I do anything thanks

System boiler and yes inhibitor is in

I have ordered a new air vent as its leaking as its not tightening up properly. however I am still having loads of air after 3 weeks , I have automatic air vents in all upstairs rads , is there anything else I can do ?

HI All On a Magnaclean air vent is it the square nut in the vent thats supposed to move or the whole round vent as on mine its the whole round vent that moves. When I tighten it back up it feels like its going tight then loose again. Should I replace it ?

Tried that and water comes out but it still sounds like air going through the magna clean

I had a radiator replaced a few days ago and now I hear gurgling through the Magna Clean like water going through it , is this air in the system ? I have rads with autoimmune vents in them , will this be enough to clear the air Thanks

It won't be seen so can I fill with easifill 60 and after 5 hours sand and paint

Hi All I am fitting a larger radiator and need to fill in the chase at each end of the radiator approx 25cm each end, I have some easifill 60 to fill the chase about 50mm deep. How long will it take to be able to sand and paint. I need it asap as the plumber can then come back and attach the...

I am having a rad changed this week for a larger rad, I have a system boiler and a tank in the airing cupboard. My question is when the plumber drains the rads will I lose all of the hot water in the hot water tank or will it only drain the heat side of the system. Many Thanks

No either side of the house

just realised the rads have been in 6 years when fitted by the new kitchen people. I dont know what make they are. photo attached

The flow into both are on the right hand side, yes they are the same rads , and both are fed by 10mm micropore. I will ring the rad company and ask if they have baffles in. Thanks

When I tried to balance them, they was the first I opened , 1st one heated up quick the other took a while , but the pipe coming into the rads get really hot so hot water is getting there

Been in about 6 years they have all ways been a bit temperamental.

Hi All I have 2 tall rads in the kitchen thats only getting tepid, I have tried to balance the system and can get the 2 rads hot but when I open up the rest of the rads the 2 tall ones go tepid again, I have a Vailant Ecotec 615 plus with 13 rads. I had the pump in the boiler replaced about 2...

Had the en-suite retiled last year but one tile now shows scratches on the tile , if I rub it to clean it , it seems to go but comes back , any way of getting rid completely thanks

Yes , you need an Allen key to fit behind to loosen the hinge

Hi All I have a Vaillant eco tec 615 plus boiler sealed system with a tank In the airing cupboard managed by a Hive thermostat and intermittently the hot water is cold when having a shower at 8pm ish. The times to heat the water are 0600-0700 1100-1130 and 1700 -1830 and it always worked ok...

Is it reasonable to expect the joiner to measure the new worktop before they cut it or is it up to the customer to point out the new worktop is wider. ( hindsight is a wonderful thing) Additional questions do most joiners fit the worktop and sink or just the worktop. Thanks