Search results

For anyone interested, the problem was that the air extract duct from the bottom of the drum was blocked with sodden, mouldy fluff. At the point the air is drawn out of the drum, it goes through rubber tube about 50mm diameter and then immediately through 90-degrees into the condensor. As...

Recently had consumer unit replaced with MK sentry job, split load. Downstairs light circuit suddendly stopped working BUT the breaker hadn't tripped. Initially thought the breaker might have died but is working OK. So inspected the connections in the consumer unit, no probs, and the...

I meant for fitting advice, a certain seller in particular is very friendly and knowledgable!

For what its worth I thought that was quite good advice!! Anyway I agree about gas stuff, can't be too careful. With a fan flue boiler though the fan is only an induction motor and an impellar. I recently gave mine a good clean and a spot of oil in the bearings because it has stopped...

The hot water tank is just a big pipe. The pressure comes from the cold tank in the loft, which presumably isn't far above your shower head. Have you considered just installing a shower pump for about £100?

This happened to my sisters machine. She tended to wash and dry a full load, whereas its only designed to dry a half load. Perhaps this causes the filter to get blocked?

There's a couple of good blokes on ebay selling parts, try a search under "Zanussi spares" and see what you get.

Might be waiting for the water to get hot, ie broken heater.

You might be interested then that under UK law you have no liability to 3rd parties for advice offered in a social context, if I understand correctly. I use the sope for diagnosing board faults, me being the type to repair them rather than just swapping them (but then there aren't exactly a...

Have you checked how cold it's getting? If its not getting that cold probably low of gas, if its freezing (or very close to) then possibly the thermostat needs replacing. If its runnings loads eventually the compressor will fail, imo.

Breezer, You seem to give the same reply to any problem anyone posts here. I appreciate your concerns and understand that you probably have safety as your primary concern, however there are those of us that like to have a go. Personally I've got en electronics/computing degree, a load of...

The cable is prone to breaking just where it goes into the machine. If you test with a multimeter between the live pin on the pug and other end of the wire, it should be close to 0 ohms. Same for the neutral wire. If it is that, simple to fix just a case of cutting about 10cm off the end of...

Model is WVF 2501, washer dryer, about 2yrs old. Seems to work OK but won't dry - doesn't seem to be any heat. What I presume to be the air heater element on top of the drum just after the fan is still showing 35-ohms across it though. Any ideas greatly appreciated!!