Search results

Thanks to everyone who gave me advice, as your advice suggested the council approved my dropped kerb and has now been completed. Thanks for your help.

Thanks for the reply, That has put my mind and wallet at rest, my crusher was limestone 40mm to dust so that sounds ok. Thanks again for putting my mind at rest.

I have created a hardstanding on the front of my property, this comprises of a 5.2*3.6m area, 10" deep hardcore/crusher, 2/3" deep plum slate. The purpose of this hardstanding is to create a drive, I have now had a few quotes for the dropped kerb and have submitted my application to the...

cheers, will try one or both

I have installed a compression flange in the top of my hot water tank, the only problem is that there is a slight leak!! it looks like I need a bigger seal/washer on there and I was wandering what type of material the washer should be made from as the cylinder will get quite hot?? Thanks

Thanks for the advice everyone

It does go into the loft to a small sealed tank covered with insulation, which then seems to go back down, if it is going to the small tank in the loft (ctrl htg expansion tank) would the tap need to be turned on or off?? cheers

I'm in the middle of fitting a bath suite and there is a tap I dont know what position it needs to be in, its located above my cws but is after the feed to the cws so I cannot see what it would isolate, it goes into the loft where i have noticed a small looks to be sealed box in insulation, can...

Thanks for all your replys, I think I will give it ago. Worse case scenario the pump does not kick in and I have to move the CWS to the loft to create enough flow.

So if I attach this PRV(http://www.screwfix.com/prods/63442/Plumbing/Radiator-Valves/Comap-PRV-With-Gauge-15mm-x-22mm) to the mains reduce it to the same pressure as the hot then have the reduced cold and hot going to the pump would this work?? Thanks

Thanks for the quick replies with regards to my cw tank being straight above the cylinder is there anyway I could use a pump with it gaining enough natural flow to initiate the pump?? Regards

First of all I would like to say Hi as I am new here, and secondly I have a question about a shower pump. I am looking at getting this pump http://www.screwfix.com/prods/46231/Bathrooms/Showers/Shower-Pumps/Salamander-Shower-Pump-CT50-1-5bar?cm_re=SEARCHPROMO-_-SHOWER%20PUMP-_-46231 My...