Search results

Can't see an obvious place for the valve - plenty of space for a very long flexible hose, but you'd still need to remove the toilet to see it once it has been fitted. There is no facility for it to be run outside the WC and then disappear through the ceramic. No instructions with it - Might...

I'm after some clarification on the replacing of a WC with a back to wall close coupled unit. The new WC is flush all the way to the floor so you cannot access the soil pipe. How do you ensure that the connector between the soil pipe/toilet is fully engaged when fitting? Also I can't see...

it's a new sealed system being installed so pressure shouldn't be an issue. If 15mm will suffice I shall use this sooner in the process then. Many thanks

Hi Neds Currently 22mm running under the floor to the bathroom. I was going to continue the 22mm up and into a stud wall where the basins will be and then split into 15mm to feed both sinks? The obviously down to 10mm near the taps. Would this be OK?

Soon to start bathroom refit. Running 22mm Hot and Cold feeds to bathroom, firstly feeding shower and bath taps and then across to two basins. Basin taps are mixers hence 10mm fittings. Question is where is the best point to begin to change from 22mm to 15mm and then 10mm required for taps...

Anyone, please? :(

I'm looking at getting a softener too. Asked my central heating chap and he recommended either Tapworks or Aquadial.

Ordered an 'Omnitub' bath to arrive in two weeks and just looking at the fitting instructions. Have read elsewhere that you shouldn't use plumbers maite on plastic sinks etc. you use silicon to seal around wastes/overflow. Is this the same case for a fibreglass bathtub? And should I...

Thanks Noseall. Looks like I'm on the right track! :D

Hi all, New to the forum and browsing for days to gen up on my bathroom refurb. Just want to check I get this right before I start! On removing old wall tiles I will no doubt damage the plasterboard on the one stud wall seperating the bathroom and bedroom, so I was going to replace the...