Search results

The E.vessel is beside the water tank in loft not near pump nor boiler. When cold the pressure is 1.2 but when heating on can go up to about 1.8 or so. No movement in the when the boiler/pump starts just gradually goes up when heating on for a while.

Not sure what the E.vessel is if it's the red thing where I check the pressure not sure if it's on the flow or return, how would i check this? The pump is picture and setting its on is attached

Hi I got an old oil boiler replaced with a new grant votex boiler and the system is now pressurised which was previously gravity fed. It's a bungalow and I have a mix of micro bore rads and 15mm run from boiler for new rads some under floor piping anf some up and down from loft. Everything I...

One other thing i have been advised that as the the chimney flue sit tight back in the chimney I need a T fitting coming from back of stove to allow room around for air circulation (will give roughly 6 inches at rear of stove) but when I read the manual the min requirements for rear and side...

Yes thanks not intending to anyway

Yeah the stove i have is for 6 inch flue and from what I am reading 6 inch flue is better for the bigger stoves for efficiency and heat??

6 meters of the liner is not cheap stuff and my stove setup is for 6 inch flue. What was your stove setup if you initially tried 6 inch liner?

Did you have someone try pull it down from ground as well?

My chimney has 8inch clay flue and I an installing a stove with a 6 inch flexible liner, has anyone ever had any trouble dropping liner down a chimney like this? Would like to hear if it was no trouble or big trouble.

Yes

Hi I have a standard extractor fan in an en suite but it doesn't do the job I need, ie walls soaking after shower. Would anyone recommend a good ceiling extractor fan over shower out via a roof vent? If you have links that would be great. Thanks

Thanks everyone

has to be signed off by a register installer (HETAS). i cannot drop the lining down chimney either but could do the rest if viable.

vent is same as tumble dryer vent, stove is 8kw

just looking, I have a air vent in the room where the open fire was and i see stove are required to have an air vent installed. will the existing air vent be adequate. thanks

Anyone on here know any stove fitters in Northern Ireland please?

Fitter tried to manipulate the chimney lining down but no joy must be a bad bend in the chimney. Not sure what is going to happen now

Just before my Chimney lining is installed Has this been a difficult job? I understand certified installer has to do it just wondering.

All done now ready for cladding

Got concrete screws to screw cement fire board but will not screw in. 7.5 x 60mm (Box of 100) Easy Drive Countersunk Direct Concrete Screws. Free Torx bit included https://amzn.eu/d/9Oz2P2k That's type I got what am I doing wrong?