Search results

The common one is 7 lb, try that first if not it might be 9 lb Stan

As far as I know Tony they dont. Thats the good thing about them. They are not like the Worc Highflows that drop down to a **** poor rate. They do 20 l/min all the time. Looks very good on paper! Stan

Might be a duff PCB. If the relay is dropping out then this will cause a similar fault Stan

It does pump over run into the rads but that should only be for a matter of seconds. I would suspect that your divetor valve is passing and heating the rads up while the tap is on! and you are probably only noticing after the tap is turned off Stan

Looks to me llike a nice fully pumped S plan. Are yopu sure its one pipe?! And by the way its been maintained at somepoint by BG because the Blue ACL is one of theirs. Try and take a look at the pipework under one of the rads. If both ends of the rad are supplied from one pipe then tough...

Very true guys and yes I remember the 621 and 623 sauniers aswell. Only time will tell I guess, but for now people are saying they are hard and they are not. In 15 years time I could say that about a lot of boilers. Even Ecotecs have gone plastic and that and the Ecomax have a rubber pipe...

I have installed about 50 Worcesters either Si or Junior since this time last year. Have never been back to any yet!, but I have been tp others and I have to say that the full water section is NOT difficult to take out. If anyone who is saying its not has actually done one then fair enough...

Could be calorifier passing aswell Stan

When terminating make sure you cut it with a hack saw, dont use a pipe slice or wheel cutters. Cut back the plastic cover about 30mm then rewrap upto the fitting after testing and so on. Usual dimensions above screed and such apply.(is it 25mm I think) Fitting has olive in two halves and...

Is a job for a corgi really but point them in the direction of ignition lead/probe problems or just blocked pilot. Stan

I would say its the divertor valve personally. Specifically the Diaphram Stan

Nige you have a better memory than me old boy :) Stan

Cant remember if these have the aqua sensor like the Ecomax. Either that or the calorifier is scaled to buggery and its not transfering heat. Stan

Dan most of the big names are O.K. Sentinel, Fernox infact I cannot think of one that isnt as most cater for alloy heat Ex's now. Stan

Yes Stan

Would love to get a job on a 9.24. Think they have all but gone around here. Great boilers but yes they are old now. Can still get alot of bits though. OP is it the electronic or does it actually have a push button and spark for a pilot light.Are you saying you can hear it sparking to try and...

Always like a nipple in each hand Bri :P Stan

Hoyboy hang on....I will hunt out my turn pin and bend bolt for you and if you really want to resolder I will lend you my mole skin for a nice wipe joint. Dont use a normal blow lamp. They are far to hot. you can also borrow my Meths mouth lamp aswell. Am I generous or what :shock: Stan

Well said. If it works on 2 then leave it there and tell him how much electricity he will be saving! :) Not that much but what does he know. Stan

The ones I have worked on were cast from memory but Im not sure what. Stan