Search results

Is it screed under it or plywood ?

Warm them up with a hairdresser the use a knife to get a corner up. Hopefully the glue strength is less then the screed strength so the scredd stays down.

But if gluing ig all down you should get way with the 1st.

Cant use the 1st one. Thats for glue down. You need an expansion gap. Need the 2nd one. Look on stairs rods website. https://stairrods.co.uk/ali-top-nose

What type of lvt are you using ? Click or dryback ( gluedown )

Use a mallet to knock the trim down before you fit it.

Yes mate ive gone over floors like that liads of times with na

Get a 5mm coat of ardex na on it. Does the sub floor have a DPM under it ?

Micro gap ? Where is the gap. Is the laminate under the skirting ?

Ardex na or similar Ardex DPM1c or Fball F77 Ardex na again Polysafe

So start with the screed. That went down with a visqueen Dpm under it What date was that done ? The the UFH on top direct ?

This would do though https://www.screwfix.com/p/bostik-general-purpose-mortar-grey-5kg/36857

Ardex A45 would be ideal

I take it you mean cushion floor vinyl ? Have you got a picture

T&G is the best locking system imo. No creaking which you can get with some click woods. You need to glue each side and use ratchet clamps to hold it all together while the glue sets. Get a good underlay. We use Timbermate excel.

You can prime with just water which will help minimise pin holes. Or use rapid repair / feather finish before the Dpm. On the walls if the skirts are off we do 10mm onto the bricks but no higher. Not sure how well the bond would be going over old bricks. But then we put foam strips around the...

It will be ok. Just needs to be thicker on the pin holes. It’s because you can’t prime it properly when doing the 1st coat.

Wouldn’t go with that underlay. I’d use Treadaire Ambiance or Chromium both 9mm and high quality.

fitting planks towards the patio doors

Be fine grinding it or sanding it if the primer was done correct.